Konix DRAKKAR OLRUN Mode D'emploi page 6

A
STAND ASSEMBLY
Keep the foam underneath the monitor before attaching the stand.
1. Open the package, take out the product with foam still attached,
and gently place it on a desktop or table.
Stand Stem
Monitor
2. Turn the bracket on a slight angle and align it with the circular slot
of the base. lnsert the bracket into the base, and then rotate clockwise
to clamp the bracket into the base to complete the installation of the base.
2.1 2.2
Align stand with Keep the bracket
the base slot. and the base
close, rotate the
bracket clockwise.
3.
Align the stand with the slot at the rear of the monitor, and insert the stand
into the monitor. To prevent damage during assembly, ensure the monitor is
still in the original foam.
Place Stand to the slot of monitor, and push up.
6
All manuals and user guides at all-guides.com
2.3
Make the bracket
click into the base.
Stand Base
Foam
2.4 2.5
lnsert screws to Complete stand and
base and tighten. base assembly.