Publicité
IMPORTANT
You must build the Palermo Gazebo before you attached the Ledro walls.
Before beginning please refer to the Assembly Manual in the Palermo Gazebo carton.
Please read these instructions carefully before you start to assemble this product.
Please carry out the steps in the order set out in these instructions.
Keep these instructions in a safe place for future reference.
Safety advice
For safety purposes we strongly recommend the product to be assembled by at least two people.
Some parts may have sharp edges. Please be careful when handling components. Always wear
gloves, eye protection, and long sleeves when assembling or performing any maintenance on
your product.
Do not attempt to assemble the product in windy or wet conditions.
Do not attempt to assemble the product if you are tired, have taken drugs,
medications or alcohol, or if you are prone to dizzy spells.
Dispose of all plastic bags safely - keep them away from children's reach.
Keep children away from the assembly area.
When using a stepladder or power tools, make sure that you are following
the manufacturer's safety advice.
Do not climb or stand on the roof.
Do not hang or lay on the profiles.
Heavy articles should not be leaned against the poles.
Keep roof and gutters clear of snow, dirt & leaves.
Heavy snow load on the roof can make it unsafe to stand below or nearby.
If color was scratched during assembly it can be fixed.
Cleaning instructions
In order to clean the product, use a mild detergent solution and rinse with
cold clean water.
Do not use acetone, abrasive cleaners, or other special detergents to clean the panels.
Clean the product once assembly is complete.
Before starting assembly
Choose your site carefully before beginning assembly.
The ground surface must be perfectly flat and leveled and have a solid base such as concrete,
asphalt, deck etc.
Sort the parts and check against the content parts list.
Parts should be laid out close at hand. Keep all small parts (screws etc.) in a bowl so they do
not get lost.
Please consult your local authorities if any permits are required prior to constructing the product.
During Assembly
UI
When encountering the information icon, please refer to the relevant
assembly step for additional comments and assistance.
This icon indicates
that the installer should
be inside the product.
This icon indicates that
1
the installer should be
outside the product.
When encountering these icons, you are requested to either
keep the screws slightly loose or to fully tighten the screws.
an.
Attention
During assembly use a soft surface below the parts to avoid scratches and
damages.
Please make sure you install the panels with the UV protected side
out (marked with "THIS SIDE OUT") and remove the sticker as panels are in place.
Step 1: Please assemble the gazebo as per its instructions. Do not assemble the plastic
corner pieces (part #8327), the plastic clips (part #7829) and do not anchor to the base
you prepared in advance!
Step 2: Dismentle the internal foot -pads (part #212 or 8758).
Step 4: During assembly, from this step onwards, use a carton or other soft material below
the parts to avoid scratches and damages.
Step 6: Peel the film from the panels'edges before sliding them into the profiles, peel the
entire film once the assembly is complete.
Step 12: Note - done from inside the gazebo.
Step 21: Apply silicone on the inside in order to seal as shown in drawing a. Screws and
corner cover are supplied with the gazebo!
Step 22: Make sure the gazebo is leveled prior to anchoring the corner poles, use suitabled
screws and plugs as per your chosen base.
Step 24: Make sure the entire gazebo is leveled prior to anchoring it to the surface of your
choosing. Use suitable screws and plugs.
Step 25: Install the sealing strip on the outer side as shown in the diagram. Use mild soap if
needed.
Tighten all screws at the end of assembly.
Note:
Anchoring this product to the ground is essential to its stability and rigidity.
It is required to complete this stage in order for your warranty to be valid.
Publicité
