Publicité
Les langues disponibles
Les langues disponibles
Chime doesn't sound:
• Red light on the transmitter doesn't light. Check polarity of batteries. Re-
place the transmitter batteries.
• Red light on the transmitter does light. Make sure the transmitter and the
chime channels are the same (see page 5). Make sure the plug-in chime
has power going to it.
Battery seems OK, but the chime doesn't work when installed:
• Don't mount the transmitter on metal or near metal studs. This reduces the
transmitter range. Use 1/4" to 1/2" (6 to 13 mm) wood shims to move the
transmitter off the metal surface.
• Attach the microphone directly to the existing chime case very near the
ringing part (but not on it) of the existing chime.
• Try locating chime closer to transmitter.
The range of the chime can vary with location, temperature, and battery condition.
Chime false triggers to loud noises:
The Extension Transmitter has special circuitry to reduce false triggers from
most common household noises. The transmitter is designed to optimize its
response to mid-frequency sound where most mechanical doorbells operate
and to minimize response to extremely low or high frequency sounds. Also,
the desired sound must be present continuously for at least 2 seconds. This
design reduces the response to door slams, vibration, normal music and
talking, etc. Loud continuous noises such as yelling children or very loud
music may cause false triggering. When operating in a location with unusu-
ally high ambient noise levels try the remedies below.
• Turn the sensitivity control counterclockwise to reduce sensitivity.
• Mount the microphone inside the existing chime as mentioned in step 4.
This device (SL-6166-RX-A, SL-6157-A-TX) complies with Part 15 of the FCC
Rules and RSS-210 of Industry Canada. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that
may cause undesired operation.
The user is cautioned that changes or modifications not expressly approved
by the party responsible for regulatory compliance could void the user's au-
thority to operate the equipment.
Do not send products, please call the number listed below:
Technical Service: 1-800-858-8501, Ext. 7660, or visit our website:
www.desatech.com.
DESA International, Inc.
P.O. Box 90004, Bowling Green, KY 42102-9004
All manuals and user guides at all-guides.com
Troubleshooting
Regulatory Information
-6-
595-5345-05
Publicité
