Valor 1265WSK Instructions D'installation Et D'utilisation page 2

Installation
It is preferable to install the 1265WSK at the same time
as the fi replace. The kit is connected to the receiver in
the fi replace. The receiver is located near the control
valve under the burner module or on the left of the
fi rebox.
CAUTION
DO NOT PUT BATTERIES IN THE REMOTE
CONTROL RECEIVER until the wires are connected
to the burner control unit as short-circuit could result
in the destruction of the electrical components.
1. Decide where the switch is to be installed. Install
an electrical outlet box or mud ring as required (not
supplied).
2. Thread the switch wire through an access hole in
the appliance.
CAUTION
Do not run the switch wire over the top of the
fi rebox. Route the wire so it does not contact the
fi rebox.
f i r e - p a r t s . c o m
Wall Switch Harness
Valve Wire Harness
Ignition Wire Connection
(spade type connector)
Be careful when removing
and reinstallaing: not to bend or
break the spade connector
2
All manuals and user guides at all-guides.com
3. Pull out the receiver box. Remove the batteries from
4. Take the switch wire and plug it into the receiver's
5. On the outside of the fi replace, run the switch wire
6. Plug the wire into the switch plate and to the outlet
7. Reconnect the ignition wire to the receiver if it was
8. Insert 4 AA alkaline batteries in the receiver.
9. Test the operation of the wall switch—see page 1.
10. Fix the wall cover plate to the outlet box.
11. Replace the receiver in its position and as well as
Ignition Wire
Antenna
the receiver box if it contains any. You can remove
the ignition wire to improve access to the receiver.
connection slot as indicated (the other slot should
already be fi tted with the valve's wire harness
connector). See diagrams below.
IMPORTANT: The connection can only be done
one way. Do not force it or damage the pins!
into the outlet box. Use insulated type staples to
secure the wiring to framing.
box.
previously removed.
IMPORTANT: Make sure the ignition wire DOES
NOT TOUCH the receiver's antenna.
Replace the cover.
the antenna if deployed.
IMPORTANT: The antenna MUST NOT TOUCH
the ignition wire.
DO NOT USE a screwdriver or
other metallic object to remove
the batteries from the receiver or
the handset! This could cause a
short circuit to the receiver.
To avoid short-circuit to the
receiver, position the antenna so
that it DOES NOT TOUCH the
ignition wire.
IMPORTANT: The connection
can only be done one way.
Do not force it or damage the
pins on the receiver box!
©2012, Miles Industries Ltd.
CAUTION
CAUTION