Bosch DKE 985 H Mode D'emploi page 18

Setting the saturation indicator
If it becomes necessary to change the
operating mode (exhaust-air /recirculation
mode), the saturation indicator for the filter
must also be altered (see installation
instructions).
18
If you encounter a problem
If in the display F or C appears:
See "Filter and maintenance" section.
If it is not possible to operate the extrac-
tor hood:
Disconnect the extractor hood from the
mains electricity supply by pulling out the
plug or switching it off at the main fuse
box. Wait for approx. 1 minute and then
switch it on again.
If you have any questions or if a fault
occurs, please call Customer Service.
(See list of Customer Service
representatives).
When you call, please quote the following:
E-Nr.
Enter the relevant numbers into the box
above. The E-Nr. (product no.) and FD
(production date) are shown on the
nameplate which can be seen inside the
extractor hood after the filter frame has
been detached.
The manufacturer of the extractor
hoods accepts no liability for complaints
which can be attributed to the design
and layout of the pipework.
FD