Raider RD-CDIDL01 Instructions D'utilisation Originales page 14

14 www.raider.bg
Unscrew the fixing screw with cross screwdriver by turning it clockwise (left-hand thread).
Install hex key in the chuck.
Gently tap the second end of the hex key.
Unscrew the chuck.
Installation of the chuck is similar to installation, only the sequence of actions is reversed.
6.2. Replacing carbon brushes.
Worn-out (shorter than 5 mm), up or broken engine carbon brushes should be replaced. Always replace
both brushes simultaneously. Work on replacement of carbon brushes entrusted only to qualified person
with original spare parts in RAIDER service.
6.3. All faults should be repaired by RAIDER service workshop.
6.4. The repair of your power is best carried out only by qualified specialists, which used only original
spare parts. This ensures their safety operation.
7. Environmental protection.
7.1. The machine, accessories and packaging should be sorted for environmental-friendly recycling.
Do not dispose of power tools into household waste!
According the European Directive 2012/19/EC for Waste Electrical and Electronic Equipment and its
implementation into national right, power tools that are no longer usable must be collected separately and
disposed of in an environmentally correct manner.
7.2. Battery packs/batteries:
Litium-Ion (Li-ion).
Warning! These battery packs contain cadmium, a highly toxic heavy metal.
Do not dispose of battery packs/batteries into household waste, fire or water. Battery packs/batteries
should be collected, recycled or disposed of in an environmental-friendly manner.
Defective or dead out battery packs/batteries must be recycled according the Directive 2006/66/EC.