Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
Cabin Air Filter
Removal & Installation Instructions
To maintain air conditioning efficiency, replace the air filter according to the manufacturer's
maintenance schedule.
Always use an air filter. Removing the filter may decrease system performance by allowing dust to
lower the efficiency of A/C and heating system components.
Prior to the installation of this DENSO First Time Fit
instructions completely.
Definition of Terms
WARNING:
CAUTION:
NOTE:
General Service Information and Requirements
WARNING: To prevent the Supplemental Restraint System (SRS, Air Bag System) from
operating, remove the ground (negative) cable from the battery, then wait at least 90 seconds before
starting this procedure. This allows the backup power system to discharge.
NOTE: For more detailed instructions please refer to the vehicle manufacturer's service manual.
REQUIRED TOOLS:
‰ Safety Goggles
‰ Assorted Hand Tools
SAFETY PRECAUTIONS:
• Always wear safety goggles
Describes precautions that should be observed in order to prevent injury or
death to the user during installation.
Describes precautions that should be observed in order to prevent damage to
the vehicle or its components, which may occur during installation if
sufficient care is not taken.
Provides additional information that facilitates installation work.
Cabin Air Filter, you must read these
®
LA990009-1572.1
Publicité
Manuels Connexes pour Denso First Time Fit
Sommaire des Matières pour Denso First Time Fit
- Page 1 Always use an air filter. Removing the filter may decrease system performance by allowing dust to lower the efficiency of A/C and heating system components. Prior to the installation of this DENSO First Time Fit Cabin Air Filter, you must read these ®...
- Page 2 Cabin Air Filter Removal The information below explains necessary procedures and tools to remove and install the Cabin Air Filter (CAF). 1. Remove the glove box door. Fig. 1 2. Remove the glove box access panel. Fig. 2 3. Remove the trim panel. Fig.
- Page 3 5. Remove CAF access door. Fig. 5 6. Remove bracket. Fig. 6 7. Remove and discard the CAF. Fig. 7 Cabin Air Filter Installation 8. Install the new CAF. 9. Reinstall the bracket, the CAF access cover; the ducting, trim panel, glove box access panel and glove box door.
- Page 4 Utilice siempre un filtro de aire. Quitar el filtro puede reducir el rendimiento del sistema al permitir que el polvo disminuya la eficiencia de los componentes del sistema de aire acondicionado y calefacción. Antes de instalar este filtro de aire de cabina DENSO First Time Fit Cabin, debe leer completamente ®...
- Page 5 Remoción del filtro de aire para la cabina La siguiente información explica los procedimientos y herramientas necesarios para retirar y instalar el filtro de aire para la cabina (FAC). 1. Quite la puerta de la guantera. 2. Quite el panel de acceso a la guantera. 3.
- Page 6 Avant d’installer le filtre à air pour habitacle First Time Fit de DENSO, lire entièrement les présentes instructions.
- Page 7 Dépose du filtre à air d’habitacle Les informations ci-dessous expliquent les procédures et les outils à utiliser pour la dépose et l’installation du filtre à air pour habitacle. 1. Enlever la porte du compartiment à gants. 2. Enlever le panneau d’accès du compartiment à gants. 3.
- Page 8 Si tiene cualquier pregunta referente a la información arriba indicada, llame a la línea de urgencias de Soporte técnico DENSO al (888) 96-DENSO sin costo en los Estados Unidos y Canadá o a DENSO directamente al (310) 834-6352. Pour les mises à jour d’application et photos, visitez le site www.densoautoparts.com.