Publicité
Les langues disponibles
Les langues disponibles
GUIDE FOR ASSEMBLING THE BIKE
1
Preparation
Tools needed: Please open the carton from the
top. Take out the bike and all parts. Find the small
tool case and open it. Take out the tools from the
tools case. You will also need a knife or scissors to
cut the fixing tapes on the bike and parts. Take care
not to scratch or mark the bike.
2
Adjustment of brake
Fine adjustment screw
1
Brake
calipers screw
Plain washer
Brake calipers
Nylon
lock nut
Arc washer
1
Install brake calipers
Loosen the lock nut behind the brake first, take out the outer arc washer and flat
washer, and then assemble the arc washer, plain washer and lock nut in turn
through the front fork. Match the arc washer with the casing surface of the front
fork, and then tighten the lock nut. After installing the front wheel, then adjust the
brake caliper. (For details, please refer to general use, maintenance and simple
repairs)
06
2
Fine adjustment
screw
Spanner
Lock nut
Brake rubber
2
Adjustment of brake calipers
If the distance between the brake rubber and the wheel rim is large, turn the
adjusting screw counter-clockwise and then tighten the adjusting nut. Conversely,
turn the fine adjustment screw clockwise (For details, please refer to general use,
maintenance and simple repair of bikes). If the brake rubber is left or right, use a
thin wrench to adjust the milled flat part of the center seat, hold the brake handle
to make the two brake legs swing at the same time, so that the gap between the
wheel rim and the left and right brake rubber is equal. The clearance between the
forklift block and the upper edge of the rim is 1-2 mm, and it is parallel to the rim.
3
3
Adjustment of V-brake
Adjust the distance between the brake block and the steel rim by 1-2mm
(0.039-0.079 inch), and keep the forklift block parallel to the rim surface. For the
adjustment of unilateral force, if there is a fine adjustment device, the cross
screwdriver can be used to adjust the clockwise rotation to increase the elasticity,
and the counter-clockwise rotation to reduce the elasticity. So that the elasticity
on both sides is equal. If the fine adjustment does not work, loosen the fixing
screw, and there are three small holes on the fixing seat. When the spring foot is
moved up, the elastic force will increase, which will make the distance between
the brake block and the steel rim increase, and the direction will decrease.
According to the actual situation to adjust.
Adjustment of the
brake block
07
Publicité
