Publicité
FM & FM-STEREO RECEPTION
SET THE RADIO BAND SELECTOR AT " FM " POSITION. PROGRAMS ARE RECEIVED IN MONO MODE. IN
PARTICULAR WHEN STEREO SIGNAL ARE WEAK. IT IS PREFERABLE TO RECEIVE THE PROGRAM IN
MONO.
SET THE RADIO BAND SELECTOR AT "FM-ST" POSITION FOR RECEIVING STEREO PROGRAMS. THE
FM-STEREO LED INDICATOR WILL LIGHT UP TO SHOW FM STEREO PROGRAM IS RECEIVING.
HINTS FOR BEST RECEPTION:-
-
AM : THE RECEIVER HAS A BUILT-IN AM BAR ANTENNA. IF AM RECECPTION IS WEAK, SLIGHTLY ROTATE
OR RE-POSITIONING OF THE UNIT WILL USUALLY IMPROVE THE AM RECEPTION.
-
FM : THE RECEIVER HAS A BUILT-IN FM WIRE ANTENNA HANGING AT THE REAR CABINET. THIS WIRE
SHOULD BE TOTALLY UNRAVELED AND EXTENDED FOR BEST RECEPTION.
PLAYING COMPACT DISC
GETTING START
1.
SET THE FUNCTION SELECTOR AT "CD" POSITION, OPEN THE CD COMPARTMENT BY PRESSING THE
CD DOOR OPEN BUTTON. PUT A CD DISC INTO THE COMPARTMENT AND CLOSE THE CD DOOR.
2.
FOCUS SEARCH IS PERFORMING IF DISC IS INSIDE. TOTAL NUMBER OF TRACKS IS READ.
PLAY / PAUSE MODE
1.
IF PLAY/PAUSE BUTTON IS PRESSED DURING STOP MODE, THE FIRST TRACK WILL BE PLAYED AND
THE PLAYING TRACK WILL DISPLAY AT THE LED DISPLAY.
2.
IF PLAY/PAUSE BUTTON IS PRESSED DURING PLAY MODE, GOTO PAUSE MODE AND THE PAUSE LED
INDICATOR WILL FLASHING.
STOP MODE
1.
IF STOP BUTTON IS PRESSED DURING PLAY OR PAUSE MODE. GO TO STOP MODE AND DISPLAY TOTAL
NUMBER OF TRACK ON LED DISPLAY.
SKIP MODE (SKIP UP
1.
DURING PLAY OR PAUSE MODE, IF SKIP UP BUTTON IS PRESSED IT WILL GO TO NEXT TRACK AND
DISPLAY THE TRACK NO. AND THEN CONTINUOU THE PLAY OR PAUSE MODE.
2.
DURING PLAY OR PAUSE MODE, IF BACK BUTTON IS PRESSED IT WILL GO BACK TO THE BEGINNING
OF THE TRACK, SAME TRACK NO. IS DISPLAY CD AND CONTINUOUS THE PLAY OR PAUSE MODE.
3.
AFTER STEP, PRESS BACK BUTTON AGAIN IT WILL GO TO THE PREVIOUS TRACK AND CONTINUOU THE
PLAY OR PAUSE MODE.
REPEAT MODE
PRESS THE REPEAT BUTTON BEFORE OR DURING PLAY, A SINGLE TRACK OR ALL THE TRACKS CAN BE
REPEATED. EACH PRESS SWITCH THE REPEAT MODE AS FOLLOW:-
(1) REPEAT 1
(2) REPEAT ALL
CD PROGRAMMING
UP TO 20 TACKS CAN BE PROGRAMMED FOR DISC PLAY IN ANY ORDER. BEFORE USE, BE SURE TO PRESS
THE STOP BUTTON.
1.
SET IN CD MODE.
2.
PRESS THE PROGRAM BUTTON AND THE PROGRAM LED INDICATOR WILL LIGHT UP & FLASHING.
3.
SELECT A DESIRED TRACK BY USING THE SKIP BUTTONS.
4.
PRESS THE MEMORY BUTTON TO ENTER THE TRACK INTO THE MEMORY.
5.
REPEAT STEPS 3 AND 4 TO ENTER ADDITIONAL TRACKS INTO THE MEMORY IF NECESSARY.
6.
WHEN ALL THE DESIRED TRACKS HAVE BEEN PROGRAMMED, PRESS PLAY/PAUSE BUTTON TO PLAY
THE DISC IN THE ORDER YOU HAVE PROGRAMMED. THE MEMROY LED INDICATOR WILL LIGHT UP AND
FLASHING DURING PLAYBACK
7.
PRESS STOP BUTTON TO TERMINATE PROGRAM PLAY.
/SKIP DOWN
)
(3) REPEAT OFF
E-2
REPEAT LED
REPEAT MODE INDICATOR
REPEAT 1
FLASHING
REPEAT ALL
LIGHT UP
REPEAT OFF
-----------------
Publicité
