Lurch GREEN POWER Mode D'emploi page 7

Crank
Closing screw
Funnel/housing
Pressing screw bushing
Pressing screw
Nylon seal
Clamping screw
Outlet screw (for wheat grass)
Housing clamping knob
Base
Stuffer/lever
Juice container
Fixture
Sieve
Screw wrench
The juice extractor is delivered with two spare
seals.
ASSEMBLY AND OPERATING MANUAL
• Install the parts to
(Note: The bushing of the pressing screw is al-
ready in the correct place).
• Push the housing onto the base (Fig. 1).
IMPORTANT
Pay attention that the nylon seal
rect place. The housing clamping knob
be loosened before the housing can be mounted
on or removed from the base.
• Set the clamping screw
en the small outlet screw
outlet screw you exert more pressure dur-
ing the juice extraction process (for leafy and
fibrous vegetables such as parsley and wheat
grass). This is not necessary for the majority of
fruits and vegetables.
You can also vary the distance between the
clamping screw and the pressing screw by
means of the enclosed screw wrench
der to increase or to decrease the extraction
pressure).
• We recommend that you secure the juice ex-
tractor with the fixture
• Ensure that the assembly surface is clean and
dry.
All manuals and user guides at all-guides.com
inside the housing
is in the cor-
must
on "Lock" and tight-
. (By tightening the
in or-
.
• Place the juice extractor near the edge of the
table or the working surface.
• Fix the housing firmly by turning the hous-
ing clamping knob
(Fig. 2). Use the stuffer/lever
Mount the fixture
• Position the crank
pressing screw housing and tighten the closing
screw on the crank
• Place the juice container on the side of the
socket so that it catches the juice coming from
the spout.
• Place a bowl (not included) for catching the
pomace under the outlet screw
• Put the fruits and vegetable into the funnel
, while turning the crank
direction (Fig. 4).
IMPORTANT
The foodstuff should be cut in small strips or
pieces and pushed slowly into the funnel. Here-
with, if possible, place the strips directly on the
right next to the pressing screw.
• If your encounter too much resistance, turn the
crank briefly in a counter-clockwise direction
and continue in the clockwise direction.
Do not use excessive force!
in clockwise direction
if necessary.
if necessary.
at the rear end of the
.
.
in the clockwise
5