Télécharger Imprimer la page

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

Microwave Oven
Installation Manual
IMPORTANT SAFETY INSTRUCTION
Never operate the oven when it is empty or without the glass turntable.
Introduction
Your Over-the-Range microwave oven comes complete with an installation instruction kit which contains the following three pieces of information
required to install it.
I.
This installation instruction booklet,
complete with diagrams on preparing your
cabinets and microwave oven for
installation.
II. The Top Cabinet Template, used to locate
the power cord clearance hole, cabinet
mounting holes and the vertical exhaust
location.
Important Safety Information
Grounding Instructions
This appliance must be grounded. In the event of an electrical short circuit,
grounding reduces the risk of the electric shock by providing an escape
wire for the electric current. This appliance is equipped with a cord having
a grounding wire with a grounding plug. The plug must be plugged into an
outlet that is properly installed and grounded.
WARNING - Improper use of the grounding can result in a risk of electric
shock.
Consult a qualified electrician or serviceman if the grounding instructions
are not completely understood, or if doubt exists as to whether the
appliance is properly grounded, and either:
1) If it is necessary to use an extension cord, use only a 3-wire extension
Safety Instructions
This product requires a three prong grounded receptacle. The installer must
perform a ground continuity check on the power outlet box before
beginning the installation to insure that the outlet box is properly grounded.
If not properly grounded, or if the outlet box does not meet the electrical
requirements noted, (under ELECTRICAL REQUIREMENTS), a
qualified electrician should be employed to correct any deficiencies.
CAUTION: FOR PERSONAL SAFETY, REMOVE HOUSE FUSE
OR OPEN CIRCUIT BREAKER BEFORE BEGINNING
INSTALLATION TO AVOID SEVERE OR FATAL SHOCK
INJURY. CAUTION:FOR PERSONAL SAFETY, THE
MOUNTING SURFACE MUST BE CAPABLE OF SUPPORTING
THE CABINET LOAD, IN ADDITION TO THE ADDED WEIGHT
OF THIS 85 POUND PRODUCT, PLUS ADDITIONAL OVEN
LOADS OF UP TO 50 POUNDS OR A TOTAL WEIGHT OF 135
POUNDS.
Power supply cord
a) A short power-supply cord is provided to reduce the risks resulting from
becoming entangled in or tripping over a longer cord.
b) Longer cord sets or extension cords are available and may be used if
care is exercised in their use.
c) If a long cord or extension cord is used:
1) The marked electrical rating of the cord set or extension cord should
be at least as great as the electrical rating of the appliance.
III. Instead of The Wall Mount Template,
Wall Mounting Plate, used to locate the
mounting plate holes and to locate the
horizontal exhaust location.
Please read all of the instructions
thoroughly before installing your
microwave oven.
cord that has a 3-blade grounding plug, and a 3-slot receptacle that will
accept the plug on the appliance.
The marked rating of the
extension cord shall be equal to
or greater than the electrical
rating of the appliance, or Do not
use an extension cord.
2) If the power supply cord is too
CAUTION: FOR PERSONAL SAFETY THIS PRODUCT
CANNOT BE INSTALLED TO CABINET ARRANGEMENT'S
SUCH AS AN ISLAND OR A PENINSULA. IT MUST BE
MOUNTED TO BOTH A TOP CABINET AND A WALL.
Electrical Requirements
Product rating is 120 volts AC, 60Hertz, 15 amps, and 1600 ~1700 watts.
This product must be connected to a supply circuit of the proper voltage
and frequency. Wire size must conform to the requirements of the National
Electric Code or the prevailing local code for this kilowatt rating. The
power supply cord and plug should be brought to a separate 20ampere
branch circuit single grounded receptacle. The outlet box should be located
near the cord entry point. The outlet box and supply circuit should be
installed by a qualified electrician and conform to the National Electric
Code or the prevailing local code.
This over-the-range oven was designed for use over ranges no wider
than 30inches. It may be installed over both gas and electric cooking
equipment.
1
NOTE:
IT IS RECOMMENDED THAT TWO
PEOPLE INSTALL THIS PRODUCT.
IMPORTANT:
KEEP INSTRUCTIONS FOR LOCAL
ELECTRICAL INSPECTOR'S USE.
short, have a qualified
electrician or serviceman
install an outlet near the
appliance.
2) The extension cord must be a grounding type 3-wire cord, and
3) The longer cord should be arranged so that it will not drape over the
counter top or tabletop where it can be pulled on by children or
tripped over unintentionally.

Publicité

loading

Sommaire des Matières pour MasterChef MCO160UWF

  • Page 1 Microwave Oven Installation Manual IMPORTANT SAFETY INSTRUCTION Never operate the oven when it is empty or without the glass turntable. Introduction Your Over-the-Range microwave oven comes complete with an installation instruction kit which contains the following three pieces of information required to install it.
  • Page 2 Installation Hardware Tools The following is a list of parts you may need for installing your Over-the-Range microwave oven. You will find the installation hardware contained in a packet with the The following tools may be needed for unit. Check to make sure you have all these parts. Use this time to become familiar installation of your microwave oven.
  • Page 3 Wall Construction Your Over-the-Range microwave oven should be mounted against and supported by a flat, vertical wall. Wall construction should be a minimum of 2” x 4” wall studding and 3/8” or more, thick drywall or plaster/lath. The oven must be attached to a minimum of one 2”...
  • Page 4 Ventilation system Instructions Your Over-the-Range microwave oven is designed for adaptation to the following three types of ventilation. Select the type of ventilation required for your installation and proceed to the appropriate section. A. Horizontal Ventilation System A-1. Ventilation motor This blower motor has a damper and your microwave oven is shipped assembled for a Recirculation Application.
  • Page 5 A-2. Install the Mounting Plate Step. 1 Setup position a. Draw a line down the middle of the studs(See the Wall Construction, page 3) b. Draw a vertical line on the wall at the center of the 30” wide space. NOTE: Use the wall template for the rear wall.
  • Page 6 A-3. Mounting microwave oven NOTE: IT IS VERY IMPORTANT THAT THIS OVEN BE INSTALLED BY TWO PEOPLE. IMPORTANT: DO NOT GRIP OR USE HANDLE DURING INSTALLATION. PREPARATION OF TOP CABINET You need to drill holes for the top support screws and a hole large enough for the power cord to fit through. •...
  • Page 7 Step. 4 Insert 2 bolts through 2 flat washers into holes on top cabinet floor. Tighten screws to close the gap between top cabinet and the microwave oven. NOTE: MICROWAVE OVEN MUST BE SECURED WITH TWO MOUNTING BOLTS. Dress power cord nearly in top cabinet. Install the grease filters.
  • Page 8 B-5. Connecting Ductwork Extend the house duct down to connect to the exhaust adapter. Seal exhaust duct joints using duct tape. House Duct Install the grease filters C. Recirculation Ventilation System Your over the range microwave oven has been provided with a charcoal filter for a recirculation venting application on some models. If replacement of the charcoal filter is required, contact your DAEWOO authorized dealer.
  • Page 9 Four à micro-ondes Manuel d’installation CONSIGNE DE SÉCURITÉ IMPORTANTE Ne faites jamais fonctionner le four à vide ou sans le plateau pivotant en verre. Introduction Votre four à micro-ondes au-dessus des autres est livré monté avec un kit d’instructions et d’installation qui contient les trois éléments d’information ci-dessous nécessaires à...
  • Page 10 Matériel pour l’installation Outils Vous trouverez ci-dessous une liste de pièces dont vous pourriez avoir besoin pour installer votre four à micro ondes au-dessus des autres. Vous trouverez ce matériel Les outils ci-dessous pourraient être d’installation dans un emballage fourni avec l’appareil. Vérifiez que vous disposez de nécessaires pour l’installation de votre toutes les pièces.
  • Page 11 Structure du mur Votre four à micro-ondes au-dessus des autres devrait être monté contre et soutenu par un mur vertical plat. La structure de la cloison devrait être d’une épaisseur de poteau de 2” (5 cm) x 4” (10,16 cm) et de 3/8” (0,95 cm) ou plus de cloison sèche ou de plâtre/latte. Le four doit être fixé...
  • Page 12 Instructions pour le système de ventilation Votre four à micro-ondes au-dessus des autre a été conçu pour une adaptation aux trois types de ventilation ci-dessous. Sélectionnez le type de ventilation nécessaire pour votre installation puis passez à la section qui convient. A.
  • Page 13 A-2. Installation de la plaque de montage Étape. 1 Position d’installation a. Tracez une ligne vers le bas depuis le milieu des poteaux (Voir la Structure du mur, page 3) b. Tracez une ligne verticale sur le mur au centre de l’espace vide de 30” (76,20 cm) . REMARQUE : Utilisez la plaque murale pour le mur arrière.
  • Page 14 A-3. Montage du four à micro-ondes REMARQUE : IL EST TRÈS IMPORTANT QUE CE FOUR SOIT INSTALLÉ PAR DEUX PERSONNES. IMPORTANT : NE VOUS AGGRIPPEZ PAS OU N’UTILISEZ PAS DE POIGNÉE PENDANT L’INSTALLATION. PRÉPARATION DU PLACARD SUPÉRIEUR Vous devez percer des trous pour les vis de support supérieures et un trou suffisamment grand pour que le cordon d’alimentation puisse passer à...
  • Page 15 Étape. 4 Insérez 2 boulons dans 2 rondelles plates dans des trous sur le bas du placard supérieur. Serrez les vis pour fermer l’ouverture entre le placard supérieur et le four à micro-ondes. REMARQUE : LE FOUR À MICRO-ONDES DOIT ÊTRE FIXÉ FERMEMENT À...
  • Page 16 B-5. Raccordement de la conduite Étendez la conduite de la maison vers le bas pour la raccorder à l’adaptateur d’évacuation. Scellez les joints de la conduite d’échappement à l’aide de ruban adhésif. Conduite de la maison Installation des filtres à graisse C.