❐ Make sure that you do not overfi ll the device. Excess batter mixture may escape
over the sides of the device. It should also always be possible to close the device
without too much effort. Do not try to close the device by forcing it shut.
1. Place the device on a dry, heat-resistant, fl at surface at a suffi cient distance from
fl ammable objects. Please make sure that the device is out of the reach of children.
2. Preheat the device: Connect it to a mains socket that has been properly installed.
The control lamps lights up and indicates that the device is heating up. Keep the
device closed while this is happening.
3. Once the device has reached its operating temperature (this will last a few minutes),
the green control lamp goes out.
4. To open up the lid, lift the lid fastener and pull up the lid by the lower handle.
5. Pour a blob (approx. 1 tablespoonful) of waffl e mixture into each mould on the lower
baking surface. Make sure that you do not pour too much batter mixture into the
moulds to prevent the mixture from spilling over.
6. Place one of the sticks that are supplied into the middle of each of the baking moulds.
7. Carefully close the lid without applying pressure and allow the waffl es to bake for
approx. 3-5 minutes. During baking, the green control lamp may light up and then
go out again. This means that the device is heating up again in order to maintain a
constant temperature.
8. Open the lid to check whether the waffl es are already baked to your liking or whether
they still need to be baked for a little longer.
9. Once the waffl es are ready, remove them carefully. If you do not use any sticks, re-
move the waffl es using kitchen utensils made from wood or plastic. Do not use any
metal or other sharp-edged objects so that you do not damage the ceramic coating
on the baking surfaces!
10. To bake further waffl es, close the lid of the device. Wait until it has heat-
ed up again and the green control lamp is out. Then repeat steps 3 to 8.
If you do not wish to bake any more waffl es, pull the plug out of the mains socket and
allow the device to cool down fully while it is open before you clean it and then put it
away (see "Cleaning and Storage" section).
Cleaning and Storage
PLEASE NOTE!
❐ Before cleaning the device, always remove the plug from the mains socket and allow
the device to cool down.
❐ The device is not dishwasher-safe.
❐ Do not spray cleaning agents directly onto the device.
❐ NEVER immerse the device, the cable or the plug in water or other liquids. There is
the risk of an electric shock.
All manuals and user guides at all-guides.com
17