Publicité
Les langues disponibles
Les langues disponibles
INSTALLATIONS
Precautions
Select
the mounting
location
very carefully,
referring to the following points.
Make sure that there is no fuel tank, wiring or
piping on the other side of the mounting surface.
Make sure that the installation of the unit will not
hinder the movement of the deck lid or interfere
with the spare tire, etc.
Use only the supplied mounting kit for safe and
proper installation.
Removing the transpotl screws
Find the three transport screws at the bottom of
theunit, which lockthe unit'smechanism
during
transport.
Remove
these
screws
before
installation.
Retain these screws and replace them in the
original
positions
if the unit is transported
for
service or maintenance.
Mounting angle setting levers
Be sure to change the position of both mounting
angle setting levers according
to the angle at
which the unit is to be installed.
Mounti~g angle
setting levers
Insert a
~ointed obiect such as a screw driver or
45'
0
n
'if
45
Q
RIZONTAL
HORIZONTAL
"g
ball-point
pen, etc.-into the low spot of the lever
and slide the lever to the position from among
HORIZONTAL,
45°, and VERTICAL positions.
Notes
.
Be sure to eject the disc magazine when you set the
levers.
Be sure to set both levers to the same position.
Be sure to set the levers exactly at the position (notch).
If the lever is deviate from the position, the sound may
drop out.
Care must be taken when you mount the unit at the
angle of lower than level. The disc magazine may drop
if you eject the magazine.
Do NOT turn over the unit or slide the lever when the
unit is activated. Doing so maydamagethe
mechanism
or the discs in the unit.
The mounting angle setting levers on each side of the
unit are factory-set to the HORIZONTAL
position.
When you complete the setilng, attach the supplied
adhesive labels @ over the slots.
/
~
,,.-,
0
,,, ,,.,
@
i
do
I
;," ,
: ,,/
.,
ENGLISH
4
Publicité
