KRESS KI200 Mode D'emploi page 10

*The reference point will be set to default
every time when it is rebooted.
5. Unit setting
Long press
between m, ft, in and ft+in.
The measuring unit will automatically switch
to "m" after restarting.
FUNCTIONS AND OPERATIONS
1. Single distance measurement
Press
then press
measurement.
The laser is turned off after completion of
10
measurement, and the measured value is
displayed immediately.
EN
Note: After power on, the instrument enters
the single measurement mode by default.
After selection of measuring position, press
; in other measurement modes, press
to go back to single measurement.
2. Continuous measurement (Max/Min)
Press
measurement. The continuous
measurement symbol is shown on the
screen. At the same time, the maximum
and minimum distances measured are
shown in the display. Users can press
or
*This function will be stopped automatically
after 5 minutes of inactivity.
min.
to change distance unit
to activate the laser, and
again to trigger single
button to activate continuous
to stop the function.
max.