Publicité
B. Click the items "This is my main monitor" and "Extend the desktop onto
this monitor".
C. Click "OK" to save your change.
D. Repeat steps A through C for the display icon identified by the number
one, two and three.
6. Use Multi Monitor feature. Click and drag the display icons to positions
representing the physical setup of your monitors that you would like to use. The
placement of display icons determines how you move items from one monitor to
another.
2.6
2.6
2.6
2.6
2.6
Jumpers Setup
Jumpers Setup
Jumpers Setup
Jumpers Setup
Jumpers Setup
The illustration shows how jumpers are
setup. When the jumper cap is placed on
pins, the jumper is "Short". If no jumper cap
is placed on pins, the jumper is "Open". The
illustration shows a 3-pin jumper whose pin1
and pin2 are "Short" when jumper cap is
placed on these 2 pins.
Jumper
PS2_USB_PWR1
(see p.2, No. 1)
Note: To select +5VSB, it requires 2 Amp and higher standby current provided by
power supply.
USB_PWR2
(see p.2, No. 3)
Note: To select +5VSB, it requires 2 Amp and higher standby current provided by
power supply.
Clear CMOS Jumper
(CLRCMOS1)
(see p.2, No. 15)
Note: CLRCMOS1 allows you to clear the data in CMOS. The data in CMOS includes
system setup information such as system password, date, time, and system
setup parameters. To clear and reset the system parameters to default setup,
please turn off the computer and unplug the power cord from the power
supply. After waiting for 15 seconds, use a jumper cap to short pin2 and pin3
on CLRCMOS1 for 5 seconds. However, please do not clear the CMOS right
1 6
1 6
1 6
1 6
1 6
ASRock
Setting
Default
Clear CMOS
N68-VGS3 FX / N68-VS3 FX
Short
Open
Short pin2, pin3 to enable
+5VSB (standby) for PS/2 or
USB01/23 wake up events.
Short pin2, pin3 to enable
+5VSB (standby) for
USB4_5/6_7 wake up
events.
Motherboard
Publicité
