Publicité
Les langues disponibles
Les langues disponibles
page 6
LAMP AIMING
With unit open, loosen the nut
1
and screw and aim the lamp
head to the desired position.
Nut
Washer
AC input Connector
White: Neutral
Black: HOT 120-347Vac, 50/60Hz
DESOTO
LAMP AIMING and WIRING DIAGRAM
With lamp heads aimed, begin by
2
tightening the nut until the gasket is
fully compressed.
(Torque spec: 12 in-lbs)
Gasket
WIRING DIAGRAM
DC output to the remote units.
Yellow/Red stripe (+)
Blue/Black stripe (-)
TM
LIFE SAFETY SOLUTIONS
3
Battery
Lamphead
Connector
Connector
Status LED
Heater
Connector
Connector
(CW Option Only)
Federal Communications Commission (FCC)
Requirements:
This device complies with FCC Title 47, Part 15, Subpart B.
This device does not cause harmful interference.
TEL: 740-345-9631
www.Holophane.com
With nut secure, tighten the screw to
finish aiming procedure.
(Torque spec: 10 in-lbs)
Screw
Part # 912-00032-002
© 2020, Acuity Brands Lighting, Inc.
Rev. J, 11/2021
All Rights Reserved.
Publicité
