Bimar MTO17P Notice D'instructions page 8

Fax +32 2 359 95 50
• Make sure that the cable is correctly positioned, that it is not touching hot elements or sharp edges,
is not wound around the utensil, is not twisted up on itself or in the way to prevent the utensil from
being pulled over. Check that you cannot trip over to prevent accidental falls or harm to persons.
• The appliance must not be positioned immediately under a socket.
• Do not use the appliance with a timer or a programmer or with a system that can switch on the
appliance automatically, to avoid risk of fire, since a fire risk exists if the heater is covered or
positioned incorrectly.
• The power socket must be easy to reach so the plug can be removed quickly in case of emergency.
• In the event of a breakdown or poor operation, turn the appliance off and ask for professionally
qualified help.
Attention: the toaster oven must only be operated with the crumb tray inserted correctly.
USE
First Use
The toaster must first be used empty without bread or foods in the clamps to eliminate the "smell of
new": insert the plug in the power socket, press down the lever and repeat two cycles in position "5".
The appliance could give off some smoke but this is not a sign of malfunctioning.
Attention: between times of use, the appliance must be left to cool for 1 minute, after which it can be
used again.
• Turn the timer knob (2) to the position required, the scale from 1 to 6 covers the time of 1-5
minutes. For intermediate positions the time is reduced proportionally.
• Insert the plug in the power socket and press the lever (4) downwards.
• To stop the appliance before the set time, press the stop button "Cancel"(3).
• When cooking is complete, the lever rises automatically. Remove the clamps, holding their plastic
handles, then extract the toasted sandwiches by squeezing the handles.
• After use, remove the plug from the power socket, wait for the appliance to cool and, after
cleaning, store in a dry place.
Warning: while cooking the bread slices, the top of the toaster must be left free so that heat can
escape.
Attention: the toaster oven must only be operated with the crumb tray inserted correctly (1).
CLEANING AND MAINTENANCE
Attention: before cleaning the appliance, unplug it and wait for it to cool completely.
•
The pincers can be cleaned with normal pot and pan detergent and a soft cloth, to clean the body,
use a slightly damp, soft cloth; do not use powder, abrasive or corrosive products or scouring
pads.
•
To remove any food residue that may have accumulated on the bottom, remove the crumb tray.
•
The external part of the appliance must be cleaned with soft cloth. Do not use abrasive
detergents which could ruin the surface.
•
When the device is not being used, cover it and put it in a dry place; do not immerse the toaster
oven in water or other liquid.
•
All repairs and maintenance must be performed by a qualified service center to whom you
should turn for any service (such as replacing the electric cord, etc.).
•
To replace the electrical cord a special tool is required: contact an authorised assistance centre
for eventual repairs.
•
If you decide to no longer use the appliance, we recommend making it inoperative by cutting off
the power supply cable (making sure to firstly remove the plug from the current socket), and
make any parts which are dangerous if used as toys by children safe.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
Back cover page (last page)
Assembly page 8/16