Koolatron Elite Serie Guide D'utilisation page 3

INSTALLATION
DOOR HANDLE INSTALLATION
1) Pull away the door gasket in the area where the handle is to be installed on the left side as shown
below in Fig. 1. The gasket is easily displaced by hand, no tools are necessary.
2) Align the handle with the screws installed. Tighten the screws using a Phillips head screwdriver
until the handle sets both flush and secured tightly against the door frame. (DO NOT over tighten
as this will cause damage to the handle assembly).
3) Replace the door gasket to its original position.
4) If you choose not to use the handle supplied, simply follow step 1 to access the installation screws
and remove them and then place the two decorative plugs into the two holes separately. Continue on
to step 3 to replace the door gasket to its original position.
1. door gasket
2. screws
3. Phillips screwdriver
4. handle
BEECH SHELVES
• This wine cooler is equipped with a sliding rail assembly to smoothly slide the wooden shelves out.
• The slide-out shelves allow bottles of wine to be viewed and removed easily.
• For easy access to the bottles, you may need to pull the shelves approximately 1/3 out of the rail
compartment.
• Any of the shelves can be removed to store larger bottles.
• To remove the shelves from the track, pull each shelf out to the shelf post, as shown in figure A.
Lift it up again, then slowly pull the shelf out, as shown in figure B.
• To prevent damaging the door gasket, the door should be opened fully when pulling shelves out of
the rail compartment.
Fig. 1
Fig. A
4
Recommended temperature settings
Wine conservation
Rose and sparkling
Dry/White
Red
*Temperature °C may varies between <+ 2°C
CONTROL PANEL
Press this key once
to turn the interior
light ON or OFF.
Toggles the temperature
display between
Fig. 2
Celsius and Fahrenheit.
STORAGE
This wine cooler is designed to store standard 750 ml wine bottles. Many bottles differ in size and
dimensions. As such, the actual number of bottles that you may be able to store may vary. Storing
large and/or oddly shaped bottles (including champagne and sparkling wine bottles) will decrease
the capacity of your wine cooler.
DOOR LOCK
This cooler can be secured with a lock and key. The keys are located inside the plastic bag that contains
the Instruction Manual. Inserting the key into the lock and turn it clockwise to lock the door, the metal
pin should be in engaged completely, with reverse operation to unlock the door. Take the key out and
put it in a secure location.
• It is normal that the preset temperature and display temperatures are different when using for the
first time. It will take approximately 1 hour for the unit to stabilize the temperature. Fill the unit with
your choice of wine bottles. Allow 2-3 hours of operation before they reach the desired temperature.
• The temperatures may fluctuate depending on whether the interior light is ON or OFF or the bottles
are located on the upper/middle/lower section.
• If the appliance is powered off suddenly, wait for 5 minutes before turning the unit on. It will return
to the settings applied, the temperature setting is with automatic memory function.
Fig. bz
OPERATING INSTRUCTIONS
12°C - 14°C (53°F - 57°F)
5°C - 8°C (41°F - 46°F)
9°C - 12°C (48°F - 53°F)
14°C - 18°C (59°F - 65°F)
Press to begin adjusting
the temperature for
upper or lower zone.
Temperature Press to increase or press to decrease
LED Display the temperature in 1 degree increments
Windows - upper zone : 5-13°C (40-56°F)
- lower zone : 12-18°C(54-65°F)
5
Press once to turn ON the cooler.
Press and hold for 3 seconds
to turn OFF the cooler.