Beper 70.403 Manuel D'instructions page 9

All manuals and user guides at all-guides.com
EN
Aroma Diffuser Use instructions
1.5 Add few drops of essential oil.
1.6 Turn clockwise to screw the upper shell back. Make sure to seal it well and correctly.
1.7 Please put the appliance on a flat surface.
2. Connect the USB power line to adapter and the device , then plug the adapter into a suitable socket or in an
USB charging source.
3. Wait ca. 3 minutes to make sure that absorbent cotton stick fully soaked.
4. Start operating by press the on/off switch. Press the switch again to let the device stop working.
5. The LED light turn blue when press the light switch on , and turn off when press the button again.
6. Default working time is 6 hours, the machine will automatically turn off after working 6 hours.
7. After auto- shut off, the machine will start to work again by press the on/off switch.
8. The two switches (on/off and the LED light) work individually.
Attention:
The intensity of the mist may vary depending on the temperature of the room and the amount of water in the tank.
Never use the product with mist function without water.
Cleaning:
After 5-6 uses, it is recommended to clean the product as follows:
Disconnect the product from the power outlet and remove the cover.
Remove any residual water and / or essential oil by sliding it through the tank .
Place one teaspoon of vinegar in the tank and 140 ml of warm water in the tank and leave for 5 minutes than
empty the tank.
Dry with a soft cloth, while the mist outlet can be cleaned with a stick for ears cleaning.
We recommend to replace the cotton stick randomly
The outside of the appliance can be cleaned with a soft cloth lightly damp.
Technical data:
Power: 1,2W
Adapter: Input 110-220 V – 50/60Hz - Output 5 V
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
9