Korman 504101 Notice Originale page 6

All manuals and user guides at all-guides.com
MEASURE
3. Press button (1)
ON
surement, and again to take the second measurement.
4. The height of building (third side of triangle), first and
second distance values will be seen on display.
Pay attention that the reference point of the measure-
ment (e.g., the rear edge of the measuring tool) is at the
exact same location for both measurements.
After completing the second measu-
rement, the height of the building is
calculated automatically. The last indi-
vidual measured value is indicated at
the middle line in the display, while the
final result is indicated at the bottom.
Indirect measurement: Pythagoras with three refe-
rence points (addition)
As shown in the picture, there is
another function to measure the
height of the building.
1. After switching on, press button
FUNC
(2) four times, the symbol
appears on display.
MEASURE
2. Press button (1)
ON
at the point which is to be measured.
MEASURE
3. Press button (1)
ON
surement, and again to take the second and third mea-
surement.
4. The height of building, second and third distance va-
lues will be seen on display.
Continuous measurement (tracking)
For continuous measurements, the measuring tool can
be moved relative to the target, whereby the measuring
value is updated approx. every 0,4 seconds. In this man-
ner, as an example, you can move a certain distance
away from a wall, while the actual distance can always
be read.
again to take the first mea-
to activate the laser and aim
again to take the first mea-
For continuous measurements, push button (1)
for a few seconds.
Continuous measurement automatically switch off after
100 times measurements (about 30 seconds).
The last measured value remains indi-
cated on the display. To cancel conti-
nuous measurement, you can exit this
measuring function by pressing button
(7)
exit.
Back-light function
To enable and disable the display back-light, hold the
button (6) for a few seconds.
3. Memory functions
Storing measured values
After the measurements, the data is stored automatically.
User can press the memory storage
read button (3)
store 19 contents.
Press button (4)
it allows the user to scroll up and down.
Deleting the memory
To delete the memory contents, first push the memory
storage read button (3)
display. Then briefly press button (7)
When switching off the measuring tool, the value in the
memory is saved.
4. Working advice
General information
The reception lens (12) and the exit opening of laser
beam (11) must not be covered when taking a measu-
rement.
The measuring tool must not be moved while taking a
measurement (with the exception of the continuous
measurement function). Therefore, place the measuring
tool, as far as this is possible, against or on the measu-
ring points.
Measurement takes place at the centre of the laser
beam, even when target surfaces are sighted at an
incline.
Influence effects on the measuring range
The measuring range depends upon the light condi-
tions and the reflection properties of the target surface.
For improved visibility of the laser beam when working
outdoors and when the sunlight is intense, use laser
viewing glasses (not included) and a laser target plate
(not included), or shade off the target surface.
6
. One time stop, second time
C/OFF
to check it. It can
+
or button (5)
so that is indicated in the
.
C/OFF
EN
MEASURE
ON
,
-