Wolf EC24/S Guide D'utilisation Et D'entretien page 16

CARE RECOMMENDATIONS
Care Recommendations
CLEANING
Coffee system
Stainless steel
Control panel
Coffee spout
Water tank
Drip tray
Grounds container
Pre-ground compartment
Interior
Infuser
Milk container
Milk container lid
INFUSER
DRIP TRAY
GROUNDS
CONTAINER
Service door open.
|
16 Wolf Customer Care 800.222.7820
All manuals and user guides at all-guides.com
Before cleaning, turn unit off at main switch and disconnect from electrical supply. Never submerge unit
in water. Do not wash any components in the dishwasher.
Use a nonabrasive stainless steel cleaner and apply with a soft lint-free cloth. To bring out the natural
luster, lightly wipe surface with a water-dampened microfiber cloth followed by a dry polishing chamois.
Always follow the grain of stainless steel.
Use spray degreaser to remove fingerprints and food soil. Spray on a cloth before wiping panel.
IMPORTANT NOTE: Do not spray cleaners directly on the control panel.
Clean periodically using a sponge. Remove any coffee deposits in holes with a toothpick.
Clean periodically (about once a month) with a damp cloth and mild dish soap. Rinse and towel dry.
Empty and clean drip tray before water level indicator protrudes from cup tray. Empty and clean grounds
container when 'EMPTY GROUNDS CONTAINER' is displayed. Open service door. Remove and empty
drip tray and grounds container. Wash with warm water and mild dish soap. Rinse and towel dry. Refer to
the illustration below.
Check periodically to verify pre-ground coffee funnel is not blocked.
Access by opening service door. Remove coffee deposits with a sponge and vacuum residue.
Clean infuser at least once a month. Turn unit off, then open service door and remove drip tray and
grounds container. Press two red buttons inward and remove infuser. Soak in water approximately 5
minutes, then rinse and towel dry. Do not use detergent. Replace by sliding infuser onto internal support
and bottom pin, then press "PUSH" until it clicks into place. Verify red buttons have snapped out.
IMPORTANT NOTE: Do not use detergent to clean infuser. It will remove lubricant on interior parts.
Unscrew lid, remove milk spout and intake tube. Remove froth regulator by pulling outward. Refer to the
illustration below. Wash all components thoroughly with hot water and mild dish soap. Rinse and dry
before reassembling. Components are dishwasher safe; use top rack of dishwasher.
Clean circuits in lid after making cappuccino. 'PRESS CLEAN' flashes on the display. Place a cup
under milk spout. Press and hold 'CLEAN' on the lid for 5 seconds to initiate cleaning. 'CLEANING
UNDERWAY' appears on the display. Hold 'CLEAN' until progress bar is complete. After cleaning,
remove milk container and store in refrigerator.
FROTH
MILK REGULATOR
SPOUT
INTAKE
TUBE
Milk container lid.
FROTH
MILK REGULATOR
SPOUT
INTAKE
TUBE