Ancona Alessia Manuel D'installation page 2

Installation size map:
Single Hole Installation:
Step 1: Preparation:
remove any debris from the area.
Step 2: Connect Supply Hoses: A. Screw supply hoses (2) and (3) into base of faucet body (1).
B. Screw in steel posts (4) and (5) into base of faucet body (1).
Step 3: Secure Spout Body (1) in place:
C. Insert the black rubber ring (6) into groove on bottom of
faucet body (1).
D. Insert body through sink deck hole.
Step 4: Insert Rubber and Metal washers:
E. Slide black rubber washer (7) and metal washer (8) over
1
F. Insert nuts (9a & b) onto steel posts (4 & 5).
Step 5: Securing all connections:
6
Sink Deck
2
3
4
5
7
8
9a&b
G: Connect supply hoses to main water supply.
H: Ensure all connections are tight to avoid potential
leakage.
Three Hole Installation:
T
Test Faucet Installation:
A. Move handle into "OFF" posltion.
B. Turn on water supplies. Check connections for leaks.
C. Remove aerator
one minute. This will help clean any debris that might
otherwise clog the system. Replace aerator.
D. Operate handle up and down, in cold and hot positions,
to flush water lines thoroughly.
Simply rinse the surface with clear water or
mild liquid detergents if necessary . Dry the
Maintenance:
faucet with a clean soft cotton cloth. Do not
use any cleaning agents containing
acids polish abrasives or harsh cleaners
Step 1: Insert plate (1) and rubber
washer (2) before
inserting spout body
into sink deck.
Step 2: Repeat steps 1 to 4 from
Single Hole Installation.
Step 3: Secure plate (1).
Step 4: Securing all connectors:
Ensure all connections are
tightly set in place to avoid
leakage.
and let both hot and cold water run for