Barrette rdi Serie Manuel D'installation page 5

9.
Beginning at one end of the rail section,
(Fig. 12) insert each baluster installed in Step 6
into the corresponding baluster hole into the top
rail.
To allow for baluster expansion, raise the top rail
approximately
for the mounting brackets to avoid stripping the
stainless steel screws and secure in place using
supplied screws (I) (Fig. 14).
10.
Secure the top rail to mounting brackets using
supplied set screws (J) as shown in Figure 15.
Repeat Steps 1 through 10 for each rail section.
11.
Check entire installation for accuracy before
snapping snap on bracket covers (H) for top and
bottom brackets (Fig. 16) into place.
NOTE: Bracket covers press-fit onto the brackets
perpendicular to the post; they cannot be slid into
place.
/ ". Pre-drill the holes (Fig. 13)
1
8
Fig. 15
Fig. 11
Fig. 12
Fig. 13
Fig. 14
Fig. 16
5