Publicité
Les langues disponibles
Les langues disponibles
b.
If you haven't already, replace the sensor's back
cover. Then, peel one side of the backing off the
included large adhesive pad. Align it with the
recessed area on the back of the sensor and
press firmly.
c.
Peel off the other backing paper on the adhesive
pad. Firmly press the newly-exposed adhesive
onto the desired surface for 30 seconds.
d.
Use a smaller included adhesive pad on the
magnet tab. Remember to stick it next to the
Door and Window Sensor so that the two arrows
are aligned and 3/4 inch or less apart.
14
All manuals and user guides at all-guides.com
Replace the sensor's back cover
Mount with Screws
(optional)
a.
Using the back cover as a
stencil, mark the screw holes
on your door or window frame
with a pencil. If you're using
the optional anchors, use a
drill to bore holes and place
the anchors in the holes.
b.
Take the back cover and
align the screw holes over
the pencil marks (or the
wall anchors). Place the
screws through these
gaps and tighten.
(optional)
(optional)
15
Publicité
