HOMCOM 824-048V80 Manuel D'assemblage Et D'instructions page 16

POWER
2.
FAN off by pressing the 'POWER' button again.
3. SPEED
medium, or high by pressing 'SPEED' . The speed setting is displayed on
the LED panel (shown in Fig 5) .
MODE
4.
mode, NATURAL mode , SLEEP mode and Child mode
- NORMAL Mode
- NATURAL Mode
speed(5s)→high speed(5s)→medium speed(5s), it works as per this
recycle.
- SLEEP Mode
at high speed at 30 mins, then transfer to medium speed at 30 mins and
transfer to low speed until fan stop working. 2 ） If you set the mode at
medium speed, fan will work at medium speed at 30 mins, then transfer to
low speed until fan stop working. 3） If you set the mode at low speed, fan will
work at low speed until fan stop working. The LED Display will turn off
you don't control the fan in 30 seconds, touch any button to turn on the
display.
- Child Mode
function will start. And it will work at high speed at 15 minutes, transfer to
medium speed at 15 minutes, then transfer to low speed until it take off. You
can take off oscillation function by manual. The LED Display will turn off if
you don't control the fan in 30 seconds, touch any button to turn on the
display.
:
Turn the FAN on by pressing the 'POWER' button; Turn the
You can adjust the fan speed to the desired level: low,
:
:
Pressing the 'MODE' button will set the FAN into NORMAL
:
Fan will start work at any speed you set up.
:
Fan will start work at low speed(5s)→medium
:
1) If you set the mode at high speed, fan will work
:
Fan will auto. Set up timer at 3 hours, oscillation
14
if