Lindam LD166 Mode D'emploi page 8

USING THE BABY MONITOR
Setting up the monitor is important to ensure it fits your home environment and child.
The Sound Indicator LEDs will show you the sound level in the nursery, the current volume setting of the Parent Unit and the
MUTE setting. Understanding these settings will help you get the most from your monitor.
ADJUSTING THE VOLUME
The parent unit has 6 volume settings and you can press (+) to increase the volume and (-) to decrease the volume. Additional
LEDs will light as the volume increases.
The lowest volume setting (no sound level lights) puts the parent monitor into 'silent' mode. No sound can be heard from the
parent unit, but sounds from the nursery cause the LED sound level lights to illuminate.
MANUAL MUTE MODE
The MUTE function allows you to cut out low level noises up to a level set by yourself (eg traffic noise or background static).
When a louder noise is heard, such as your baby crying, the monitor will begin to transmit continuously as normal. There are 5
MUTE sensitivity levels to select from.
1. Press the MUTE button once on the
Parent unit. You will hear a short 'Beep'
and the current MUTE level will be
indicated by the LED lights.
4. When a sound above your MUTE level is detected in your nursery the monitor will transmit all sounds. To reactivate the
MUTE simply press the MUTE Button once.
NOTE: The MUTE function can be turned off at any time by pressing the MUTE button again.
NOTE: The MUTE mode is different to the 'Silent' mode that can be achieved by fully reducing the volume.
NOTE: The MUTE mode will not activate if the sounds from the nursery are already above the MUTE level.
All manuals and user guides at all-guides.com
2. Within 2 seconds of pressing the
mute button use the (-) button to filter
more sound or the (+) button to filter
less sound. The level will be indicted by
the LEDs.
8
G
H
3. The MUTE Active LED will remain lit
and only sounds greater than your pre-
set level will be transmitted.