NightStick NSP-9842XL Manuel D'instructions

Instruction Manual
NSP-9842XL
THANK YOU FOR SELECTING THE NIGHTSTICK NSP-9842XL!
US PATENT 9,713,217 AND 10,088,138
Please read these instructions before using your 9842XL. They include
important safety and operation information.
WARNINGS
Included in the box - Compris dans la boîte - Incluido en la caja
 NOT FOR USE IN HAZARDOUS LOCATIONS. Do not use this product
in explosive atmospheres, near fl ammable liquids, or where explosion proof
or intrinsically safe lighting is required.
 DO NOT use this product in the proximity of vehicles or equipment when
there is a risk of fl ammable liquids coming into contact with the fl ashlight.
 Light can become hot while on. To prevent damage DO NOT cover or
place next to any potentially fl ammable materials while in use.
 Keep out of the reach of children.
CR-123 BATTERY CARRIER
Load two CR-123 Lithium batteries with the positive terminals pointing in
the direction of the arrow. NOTE: The fl ashlight cannot be charged with the
CR-123 CARRIER installed.
Bayco Products, Inc. • 640 South Sanden Blvd. • Wylie, TX 75098 • 1-800-233-2155 • 1-469-326-9400 • www.nightstick.com
All manuals and user guides at all-guides.com
STROBE WARNING
nausea. A very small percentage of people suffer from photosensitive epilepsy
and may experience seizures or blackouts triggered by strobing lights. For
more information from the EPILEPSY FOUNDATION about photosensitivity
and seizures, please visit www.epilepsy.com. Anyone who has had symptoms
linked to this condition should consult a doctor before using this product.
OPERATION
brightness
fl ashlight, fl oodlight, dual-light and strobe. The 9842XL has a unique tail-
switch that operates both the fl ashlight and fl oodlight in one confi guration.
Momentary Flashlight Mode
fl ashlight on) for momentary operation. Release the switch to turn the light off.
Constant-on
then release for constant-on in high-brightness mode. Press and release the
switch to turn the light off.
Select Brightness Level
will cycle from high to medium to low and then back up again at a rate of
approximately one mode per second. The light will continue to cycle up and down
through the various modes as long as the switch is held down. When the desired
brightness level is reached, simply release the switch, and the light will remain in
that brightness mode. Press and release the switch to turn the light off.
Floodlight
release for fl oodlight mode. Press and release the switch again to turn the
light off.
Dual-Light
level) and the Floodlight, at the same time. First select the appropriate
brightness level of the fl ashlight using the directions above. Next press and
release the bottom switch to activate the fl oodlight. Both the Flashlight and
the Floodlight are now running. Press and release both the upper and lower
switches to turn the light off.
Strobe Function
tail switch to activate the strobe function running at full brightness. Press and
release either switch to turn the light off.
WARRANTY
LIMITED LIFETIME WARRANTY
workmanship and materials for the original purchaser's lifetime. The Limited
Lifetime Warranty includes the LEDs, housing and lenses. Rechargeable
batteries, chargers, switches, electronics and included accessories are
INS-NSP-9842XL-18
Exposure to strobing lights may cause dizziness, disorientation, and
The 9842XL has seven light modes: momentary fl ashlight, full
fl ashlight, medium
Lightly press the upper raised portion of the tail switch (without clicking the
Fully press the upper raised portion of the tail switch until it clicks and
Press and hold down the upper raised portion of the tail switch. The light
Press the bottom recessed portion of the tail switch until it clicks and then
Dual-Light allows the user to turn on both the Flashlight (at any brightness
From off or any mode, rapidly double click the upper raised portion of the
Bayco Products, Inc. warrants this product to be free from defects in
brightness fl ashlight, low brightness