Publicité
OPERATING INSTRUCTIONS
6. Plug the Power Base into a 120V ~ 60 Hz electrical outlet.
7. Press the ON/OFF Lever down, into the ON position. The Indicator
Light inside the Lever will illuminate.
8. When the water comes to a boil, the Kettle will automatically shut
off and the Indicator Light will turn off.
NOTE: The Kettle can be turned OFF any time during the
heating process by lifting the ON/OFF Lever up.
WARNING: This appliance generates heat and escaping
steam during use. Proper precautions must be taken to
prevent the risk of burns, fires, or other injury to persons
or damage to property. Keep hands and face clear of the
area above the Kettle.
9. Remove the Kettle from the Power Base before pouring.
CAUTION: Always make sure the Kettle is OFF before
removing it from the Power Base.
CAUTION: To avoid a risk of splashing, make sure the Lid is
securely closed onto the Kettle before operation. Pour
slowly and don't over tilt the Kettle.
CAUTION: Do not touch hot surfaces! When you lift the Kettle
from the Power Base you may notice moisture on the
Power Base surface. This is the steam used to switch the
Kettle OFF automatically, which then condenses and
escapes through the vents in the underside of the Kettle.
This is normal and should be ignored.
10. To reheat water, check the water level to ensure it is above the MIN
water level. If necessary, add more water, then place Kettle back
onto Power Base. Be careful not to spill any water onto the Power
Base. Press ON/OFF Lever down, into the ON position.
CAUTION: When refilling, take care when lifting the Lid, as
the Kettle, if hot, may be full of steam. Keep your face,
hands, etc. clear of the opening.
11. Unplug the Power Base when not in use. Allow it to cool before
reuse. Empty the Kettle after each use. Do not leave water in the
Kettle overnight.
(Continued)
6
Publicité
