Electromagnetic Compatibility Information - Hydas Body Max 4508.1.00 Mode D'emploi

ELECTROMAGNETIC COMPATIBILITY INFORMATION

Guidance and manufacture's declaration - electromagnetic emissions
The 4508 is intended for use in the electromagnetic environment specified below.
The customer or the user of the 4508 should assure that it is used in such an environ-
Emissions test
RF emissions
CISPR 11
RF emissions CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/
flicker emissions IEC
61000-3-3
Guidance and manufacturer's declaration - electromagnetic immunity
The 4508 is intended for use in the electromagnetic environment specified below.
The customer or the user of the 4508 should assure that it is used in such an environ-
IMMUNITY test
Electrostatic
discharge (ESD)
IEC 61000-4-2
Electrical fast
transient/burst
IEC 61000-4-4
For all ME EQUIPMENT and ME SYSTEMS
Compliance
Group 1
Class B
Not
applicable
Not
applicable
For all ME EQUIPMENT and ME SYSTEMS
IEC 60601 test
level
± 6 kV contact
± 8 kV air
±2 kV for power
supply lines
ment.
environment-guidance
The 4508 uses RF energy only for its inter-
nal function. Therefore, its RF
emissions are very low and are not likely to
cause any interference in nearby electro-
nic equipment
The 4508 is suitable for use in all
establishments other than domestic and
those directly connected to the public
low-voltage power supply network that
supplies buildings
used for domestic purposes.
ment.
Compliance
level
± 6 kV contact Floors should be wood,
± 8 kV air concrete or ceramic tile. If
floors are covered with
synthetic material, the relative
humidity should be at least
30 %.
not applicable not applicable
(For INTERNALLY POWERED
ME EQUIPMENT)
Electromagnetic
Electromagnetic
environment-guidance