Publicité
Les langues disponibles
Les langues disponibles
Make sure the unit is unplugged.
1. Separate the tank from the
body of the unit.
3. Pour cool, clean water directly into
the tank. Do not pour anything but
water into the tank.
5. Attach the tank to the body of the
unit and plug in.
E-6
2. Open the tank lid, turning it to
the left.
4. Close the tank lid, turning it
to the right.
6. Press the button to turn on.
•
Always unplug the unit before servicing it in any way.
•
Do not submerse the unit in water, or allow water to enter the inside of the unit.
INSIDE THE BODY OF THE UNIT
Pour excess water out of the unit. Wash out the unit with fresh water, using the cleaning
brush and a soft cloth as needed.
OUTER SURFACE OF THE UNIT
Wipe the surface of the unit with a soft damp cloth if needed.
WATER TANK
Fill water tank with clean water and shake to remove water scaling.
ULTRASONIC DISK
Remove the water tank (Figure 1) and use the enclosed cleaning brush regularly to
remove build up and deposits from this area (Figure 2).
Do not use any detergents or soap as this may damage the ultrasonic disc. This may
also disperse detergent or soap residue with mist causing bodily harm.
Do not scrub with finger tips or any sharp objects as this may cause damage
to the ultrasonic disc.
If there is red color build up on ultrasonic disk, gently clean with soft cloth and
1-2 drops of white vinegar. Rinse with clean water.
*Clean the disk with the brush only. No other cleaning tool should be used. Brush only. (Fig. 2)
•
Fully dry the inside and outside of the unit before storing it.
•
DO NOT leave water in the unit.
•
Store in a cool, dry place.
E-7
Publicité
