Device Settings - Adam Hall CAMEO TS 200 FC Manuel D'utilisation

STAND-ALONE MODE DIRECT (Direct)
Stand-alone for setting the overall brightness (Dimmer), the stroboscope (Strobe), and the color mixing of R, G, B, A, L, and C (Red, Green, Blue,
Amber, Lime, Cyan). You can access the options menu by pressing MENU. Using the UP and DOWN buttons, now select the "Mode" menu item
(bottom row) and confirm via ENTER. Afterwards, select the "Direct" menu item by using the UP and DOWN buttons again. Confirm with ENTER.
Now use UP and DOWN to select the submenu item you'd like to edit and then press ENTER. Set the desired value by pressing UP and DOWN
(hold down to quickly change values) and confirm via ENTER. Press MENU again to return to the main screen. If there is no input within approx.
30 seconds, the main screen is automatically activated. If the main screen is activated, the overall brightness (dimmer) can now be set directly
(UP and DOWN buttons).

DEVICE SETTINGS

You can access the options menu by pressing MENU. Using the UP and DOWN buttons, now select the "Settings" menu item and confirm via
ENTER. This will take you to the submenu for setting the submenu items (see table, select via UP and DOWN, confirm via ENTER, change status
via UP and DOWN, confirm via ENTER): Press MENU again to return to the main screen. If there is no input within approx. 30 seconds, the main
screen is automatically activated.
Settings (bold = factory setting)
DispBack = Display backlight
DMX Fail = Operating mode for DMX signal interruption
Fan = Adjust fan control
RedShift = Imitates color drift of a halogen spotlight
when dimming. The dimming of the spotlight
automatically changes the color temperature
along a rising curve of warm white and amber
(and vice-versa).
DimCurve = Dimmer curve
Backlight on Permanently on
Backlight off
Deactivates after approx. 30 seconds
of inactivity
Hold Last DMX command is retained
Blackout Activates blackout
Auto Automatic fan speed control
Silent Extra quiet fan (with reduced brightness,
if required)
On Color drift activated
Off
Color drift deactivated
Linear Light intensity increases linearly
with DMX value
Expo Light intensity can be finely adjusted at
lower DMX values and broadly adjusted at
higher DMX values
Log Light intensity can be broadly adjusted at
lower DMX values and finely adjusted at
higher DMX values
S-curve Light intensity can be finely adjusted at
lower and higher DMX values, and broadly
adjusted at medium DMX values
9