Prem-I-Air EH1566 Mode D'emploi page 3

All manuals and user guides at all-guides.com
This appliance can be used by children aged from 8 years and above
•
and persons with reduced physical, sensory or mental capabilities or
lack of experience and knowledge if they have been given supervision
or instruction concerning use of the appliance in a safe way and
understand the hazards involved.
Children shall not play with the appliance.
•
Cleaning and user maintenance shall not be made by children without
•
supervision.
Place the EH1566 on a firm flat surface. Ensure that the air inlets (at the
•
bottom) and the air outlets (at the top) are not obstructed.
Ensure that curtains are at least 900 mm (3') from the top of the heater
•
Leave a gap of at least 50 mm (2") at the sides of the heater.
•
Do not place on soft surfaces.
•
For indoor use only.
•
Do not use in the immediate surroundings of a bath, a shower or a
•
swimming pool.
Do not place the mains lead beneath a carpet or rug.
•
Do not use the heater in locations where paint, petrol or other flammable
•
liquids are used or stored.
Do not locate the appliance immediately below a socket outlet
•
GENERAL SAFETY REQUIREMENTS
Domestic wiring must be tested periodically by a qualified electrician at least
once every 10 years or at every change of occupancy.
For office and retail premises, and buildings such as village halls, the wiring must
be inspected at least once every 5 years.
It is recommended that all buildings be fitted with smoke alarms (it is mandatory
for new buildings)
If not permanently installed, plug the mains lead into a 13 Amp mains socket.
When the heater is first used, rotate the thermostat fully clockwise. Then switch
the heater on. When the room has reached the required temperature rotate the
thermostat anticlockwise until it is heard to click. The thermostat will now
maintain the room at this temperature. Small adjustments to the room
temperature can be made by rotating the thermostat a small amount
anticlockwise (for cooler) or clockwise (for warmer).
When the room temperature has been set, it will not be necessary to adjust the
thermostat again.
PRODUCT SAFETY
Do not cover. This symbol shown on the casing of the
•
heater means that the heater should not be covered.
SETTING UP
3