TEKTELIC COMMUNICATIONS KONA MICRO GATEWAY Mode D'emploi page 14

Figure 6: Battery Installation
2.6 RF Cable Installation
The Kona Micro Gateway installation requires connection to a LoRa RF antenna. The antenna
attaches to the reverse SMA connector located on the side of the Gateway. Torque the connector
to 5 in·lbs. The Kona Micro Gateway is not protected from lighting surge as it is intended for
Indoor use. Do not connect directly to an outdoor antenna.
Note that the 3G/4G modem antenna is internal to the Kona Micro Gateway.
2.7 Copper Ethernet Cable Installation
The Kona Micro Gateway Ethernet port may be used on a temporary basis for commissioning and
maintenance or may be permanently connected for backhaul and/or optional PoE.
The Ethernet cable must have minimum 24 AWG conductors and shall be rated for indoor
application according to local and national electrical codes.
2.8 Proposition 65 Statement
WARNING: This product can expose you to chemicals including lead, beryllium, cobalt oxide,
nickel oxide, carbon black and lithium nickelate & nickel, which is known to the State of California
to cause cancer, birth defects or other reproductive harm. For more information, go to
www.P65Warnings.ca.gov.
Kona Micro Gateway User Guide T0008073_UG Version 1.1
TEKTELIC Communications Inc. Confidential Page 14 of 26