Publicité
Les langues disponibles
Les langues disponibles
S
PEAKER CONNECTIONS (TRI-MODE)
The BA260, BA460, BA2100, BA2150HC, are capable of running in a Mono / Stereo mode. This
feature gives the amplifier the ability to run stereo satellites (midbass & tweeter)
simultaneously with a mono subwoofer.
These connections are more complicated because they require the use of passive
crossover networks (Not provided) to divide the frequencies to the speakers. We have
included a sample diagram for 4 Ohm connections. If you wish to use multiple speakers to
achieve a lower impedance and higher power, it is strongly recommended that you seek
professional advice from your BAZOOKA retailer before attempting to make these
connections.
Please Note: In the Tri-mode configuration, the amplifier's built-in crossover must be set to
the "FLAT" position so the speakers receive full range output.
Left
Left
Mid / Tweeter
Mid / Tweeter
4 Ohm
4 Ohm
(2 Ohm Minimum)
(2 Ohm Minimum)
L
L
NON-POLAR
NON-POLAR
CAPACITOR
CAPACITOR
CAUTION!
In Tri- mode operation, the amplifier must see a 2 Ohm load or higher for the stereo
satellites and no lower than 4 Ohms for the subwoofer(s). Any lower than the above mentioned
impedance will cause the amplifier to overheat and possibly cause permanent damage to the
amplifier.
All manuals and user guides at all-guides.com
FUSE
+12V
REM
GND
100
100
E
E
G
G
E
E
N
N
D
D
INDUCTOR
INDUCTOR
(COIL)
(COIL)
13
SPEAKER
LCH
RCH
BRIDGE
F F
100
100
+ +
- -
Mono Woofer
Mono Woofer
8 Ohm
8 Ohm
(4 Ohm Minimum)
(4 Ohm Minimum)
F F
Right
Right
Mid / Tweeter
Mid / Tweeter
4 Ohm
4 Ohm
(2 Ohm Minimum)
(2 Ohm Minimum)
Publicité
