Aluprof RM Serie Mode D'emploi page 9

4. Memorizing another transmitter
x2 BIP
Press the button "P2" twice of the
and you will hear an acoustic signal
already programmed transmitter
(x2 BIP)
5. Function with support or without support
x1 BIP
Press the "P2" button and you
will hear an acoustic signal
(x1 BIP)
6. Ereasing the memory of the motor
To clean up emiter means deleting all the memory of emiter in the motor receivers
x1 BIP
Press the "P2" button and you will
hear an acoustic signal (x1 BEEP)
All manuals and user guides at all-guides.com
Press the "P2" button of the
new transmitter
x1 BIP
Press the "UP" button and you
will hear an acoustic signal
(x1 BIP)
x1 BIP
Press the "STOP" button and you
will hear an acoustic signal (x1 BIP)
OK
After successful setup the radio
receiver will beep (x5 BIP)
Press the "P2" button
Press the "P2" button
- 9 -
x3 BIP
After successful setup the radio receiver will
beep (x3 BEEP) and move up-down.
The device will switch into operation
mode without support, repeat the
programming sequence to return to the
operation mode with support
X3 BIP
After successful setup the radio
receiver will beep (x3 BEEP)