BearDevil RED Mode D'emploi page 6

Charging the Battery
(Refilling the Bearjuice)
Screw off the rear cap and plug the USB charger to the
camera. A blue LED will show when your BearDevil is
charging, and turn off when it's done. If you're charging the battery for the
first time, let it charge for ten hours. A fully charged battery will allow for
more than 2 hours of recording time.
Turning Your BearDevil
On and Off
We've equipped your BearDevil with a state-of-the-art
"Power Button" (it's also the record button!). This button
will allow you to take full control over whether your BearDevil is in Roar
Mode ("on") or in Hibernation Mode ("off"). Push and hold the button for a
couple of seconds and a green LED will light up. Upon releasing the button a
red LED will flash twice, meaning your BearDevil is ready for action.
To turn off your BearDevil, push and hold the Power Button
until the red LED flashes.
10
All manuals and user guides at all-guides.com
Setting the
Date and Time
To set the correct time and date for your BearDevil, open a simple
text editor and write the date and time as follows:
YYYY-MM-DD hh:mm:ss
Save this file on your MicroSD memory card as "time.txt", insert it
into your BearDevil and turn it on.
Remember that, to make recordings, your BearDevil needs
to have a MicroSD memory card (class 6 or higher) inserted.
EN
11