All manuals and user guides at all-guides.com
Terminal Connections
Connections as illustrated below
Note
tighten the screws frimly, but be coreful not
to apply too much force* as doing so many
damage thee screws.
*the torque value shouold be less than 1N•m
Circuit diagram
First, place the unit where you plan to install
it, and mark postion of the four screw holes
on the surface of teh mounting board (not)
supplied). Then drill the hoes approximately 3
millimeters (mm) in diameter and mount the
unit onto the board with the supplied mount-
ing screws are 15 mm long. Therefore, make
sure that the mounting board is thicker than
15 mm.
11