OBI 450296 Mode D'emploi page 37

Winkelschleifer_450296.book Seite 37 Freitag, 24. Februar 2017 8:24 08
GB
These fluctuations will depend on the way in which the power
tool is used. Try to keep vibrations to a minimum. One method
of reducing the vibration load is, for example, limiting the length
of time you work with the tool. All parts of the operating cycle
must be taken into account for this purpose (for example, also
including times in which the power tool is switched off and
times in which it is switched on, but is running without load).
Determination of vibration emission values in accordance with
EN 60745-1.
***) Special connection conditions according to EN 61000-3-11:
Only connect the device to a power supply with an impedance
less than or equal to Z . Contact your electricity supplying
max
company if necessary.
37