Publicité
Les langues disponibles
Les langues disponibles
1074, Avenue des Carrières – Z.A la Plaine du Caire III
13830 ROQUEFORT LA BEDOULE – FRANCE
www.ermax.fr - E-Mail : accueil@ermax.fr
Fitting instructions
- Assemble the sliding guide (1) and screen fixation (2) thanks to M6 axle (5) and the nut (8).
- Insert the rubber (3) in the sliding guide (1).
- Insert the rubber (4) in the screen fixation (2).
- Place the headless screws M6 (6) in the sliding guide (1).
- Place the short headless screws M6 (7) in the screen fixation (2).
- Insert the Clip & Flip screen in the screen fixation (2) and then tighten with the grip (9).
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* The mentioned label of motorbikes's manufacturers are indicated exclusively as a reference to Ermax accessories.
* Care to excessive clampings which may damage or break our plastic accessories and aluminium screws.
* Screens damaged by an inadequat washing are not guaranteed (abrasive, corrosive ... products, solvent, thinner, benzine ...). Wash immediately brake or battery fluid which may flow on accessories.
1
Sliding guide
2
Screen fixation
Rubber low
3
part
Rubber high
4
part
M6 axle
5
x2 Headless
6
screw M6
x2 short
7
Headless screw
M6
Nut
8
Grip
9
Hex key BTR 3
« CAUTION »
FITTING INSTRUCTIONS
ERMAX UNIVERSAL DEFLECTOR
Estimated mounting time : 10min
4
2
9
3
Update 12/05/2021
EN
« CLIP & FLIP »
7
8
5
1
6
Publicité
