GreenWorks STB402 Manuel De L'utilisateur page 8

EN
8.5 REMOVE THE BATTERY PACK
1. Push and hold the battery release button (1).
2. Remove the battery pack from the machine.
9 OPERATION
Before you operate the machine, read and understand the
safety regulations and the operation instructions.
Be careful when you operate the machine.
9.1 START THE MACHINE
1. Pull back on the lock-out button (1) and pull the trigger
(2).
9.2 STOP THE MACHINE
1. Release the trigger to stop the machine.
9.3 ADJUST THE DEPTH OF CUT
1. Remove the battery pack.
2. Loosen the depth adjustment knob to increase or decrease
the depth.
Depth Adjustment Knob
3. Adjust the depth so that the blade barely touches the
ground when the machine is held in a normal operating
posture.
4. Tighten the depth adjustment knob.
5. Standing in a normal working position, check the depth of
cut again and correct if necessary.
IMPORTANT
WARNING
English
6. Replace the battery pack once all adjustments are
complete.
9.4 REPLACE THE BLADE
If the blade worn out, replace it with a new one (not
provided).
1. Use a metal rod (1) to fix the blade.
2. Remove the nut (2) by turning it clockwise with the
wrench (4) provided.
3. Remove the washer (3).
4. Remove the old blade and replace it with a new one.
5. Place the washer on the blade.
6. Place the nut on the washer and tighten it
counterclockwise with the wrench provided.
8
Blade
NOTE
2
3
Wheel
1