VOLTOMAT HEATING FH-108013.1 Mode D'emploi page 66

FH-108013.1
PARTS DESCRIPTION
1. Thermostat control switch
2. Air outlet grille
3. Heat select switch
4. Indicator light
Heat setting:
"O" position – OFF
" " – FAN
I WARM AIR (low heat output)
II WARM AIR (high heat output)
THERMOSTAT
1. Rotate the switch to choose the suitable setting ("
high heat output).
2. Turn the thermostat knob in a clockwise direction to the max position.
3. Once the room temperature has reached the desired value, turn the thermostat knob slowly in
anti-clockwise direction until you hear a "click" sound; this is the setting temperature.
4. The appliance will automatically maintain the setting temperature. It will switch on when the room
temperature is below the setting, and switch off if it is above the setting.
SAFETY SYSTEM
The appliance has a safety system which automatically switches off the unit when overheated.

If overheating occurs, switch off the appliance, remove the plug from the socket, and let it cool down

for at least 30 minutes. Put the plug in the socket and switch on the heater.
MAINTENANCE
The fan heater only needs regular cleaning on the outside.

Before you clean the unit, turn off the switch. Remove the plug form the socket and wait until the fan

heater cools down completely.
Use a damp cloth to wipe the heater housing.

Do not use detergents, abrasive cleaning liquids or chemicals (alcohol, gasoline etc.) to clean the

appliance.
TECHNICAL DATA
Operating voltage: 220-240V ~ 50Hz
Power consumption: 1800-2000W
Recycling – European Directive 2012/19/EU
This marking indicates that this product should not be disposed with other household wastes. To
prevent possible harm to the environment or human health from uncontrolled waste disposal,
recycle it responsibly to promote the sustainable reuse of material resources. To return your used
device, please use the return and collection systems or contact the retailer where the product was
purchased. They can take this product for environmental safe recycling.
"= fan only, no heat/ "I"= low heat output/"II"=
- 65 -
GBR