Télécharger Imprimer la page

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

SA-DACT Dialer Installation Sheet
EN FR
EN: Installation Sheet
Operation
The SA-DACT provides communications between the control
panel and the central station over a telephone line system. The
DACT transmits system status changes (events) to a
compatible digital alarm communicator receiver over the public
switched telephone network. The DACT queues messages and
transmits them based on priority (alarm, supervisory, trouble,
disable, test, monitor, and system). The dialer is capable of
single, dual, or split reporting of events to two different account
and telephone numbers. The modem feature of the DACT can
also be used for uploading and downloading panel
configuration, history, and current status to a PC running the
configuration utility. The modem feature uses line 1 only.
Note:
The SA-DACT is compatible with Contact ID (CID) only.
Installation
The DACT is installed on the plastic assembly and connects to
the main circuit board via a ribbon cable.
To install the DACT:
1.
Power down the panel and disconnect the batteries.
2.
Locate the dialer card slot on the plastic assembly behind
the main circuit board and connector J8 on the main circuit
board (at the top-center of the main board).
3.
Slide the DACT into the slot on the plastic assembly as
shown in the diagram.
4.
Attach the DACT to the plastic assembly using two #6
plastite screws as shown in the diagram.
5.
Connect the ribbon cable (P/N 7140188) from the DACT to
connector J8 on the main circuit board.
6.
Connect the phone lines. See "Wiring."
7.
Power up the panel and connect the batteries.
© 2013 UTC Fire & Security. All rights reserved.
Figure 1: Slide the DACT into its slot
Figure 2: Screw the DACT in place and connect the ribbon cable
1 / 8
firealarmresources.com
Main circuit board
Plastic assembly
Dialer card
Ribbon cable to connector
J8 on main circuit
board (top-center)
J8
#6 plastite screws
P/N 3101099 • REV 03 • REB 25JAN13
Card slot on
plastic assembly

Publicité

loading

Sommaire des Matières pour Edwards SA-DACT

  • Page 1 PC running the configuration utility. The modem feature uses line 1 only. Note: The SA-DACT is compatible with Contact ID (CID) only. Installation The DACT is installed on the plastic assembly and connects to the main circuit board via a ribbon cable.
  • Page 2 Note: Install a listed secondary telephone protector between for proper operation. the telco network and the SA-DACT card. The SA-DACT card must be the next piece of equipment that connects to the To conduct a dialer test: telephone company (TELCO) telephone lines.
  • Page 3 Compatibility dialer contains, among other information, a product identifier in the format US:AAAEQ##TXXXX. If requested, The dialer is listed for use with the following DACRs. this information must be provided to the telephone company. Receiver Models Formats • The plug and jack used to connect the dialer to the Ademco Contact ID premises wiring and telephone network must comply with...
  • Page 4 FR: Fiche D’Installation Fonctionnement Le SA-DACT établit les communications entre le panneau de commande et le poste central au moyen d’une ligne téléphonique. Le DACT transmet les modifications apportées à l’état du système (événements) à un récepteur de communication d’alarme numérique compatible par le...
  • Page 5 Tester le composeur automatique : SA-DACT. La carte SA-DACT doit être la pièce d’équipement suivante qui se branche aux lignes téléphoniques de la Appuyez sur le bouton Menu du panneau de commande.
  • Page 6 Compatibilité Conformité • Pour les équipements approuvés avant le 23 juillet Le composeur est utilisable avec les DACR ci-dessous. 2001 : Ce composeur est comporte à la partie 68 des règlements de la FCC (Commission fédérale des Récepteur Modèles Formats communications) Une étiquette jointe au composeur Ademco Identification de...
  • Page 7 • Si vous éprouvez des difficultés avec le composeur, communiquez avec le soutien technique de EST pour le réparer ou obtenir de l’information en regard de la garantie. Si le composeur endommage le réseau téléphonique, la compagnie de téléphone peut vous demander de le débrancher jusqu’à...
  • Page 8 8 / 8 P/N 3101099 • REV 03 • REB 25JAN13 firealarmresources.com...