Beper P205DIF001 Mode D'emploi page 7

Ultrasonic Aroma Diffuser Use Instructions
This appliance is for household use only.
To protect against electric shock, do not immerse cord, plug or any
parts of the appliance into water or other fluids.
Do not use the appliance near explosives, highly flammable mate-
rials, gases or burning flames.
Do not allow children, disabled people or every pe-
ople without experience or technical ability to use
the appliance if they are not properly watched over.
Close supervision is necessary when any appliance
used by or near children.
Product description Fig. A
1. Outer cover
2. Water tank lid
3. Atomizer cover
4. Water tank
5. Light button
6. Timer and mist button
Operating instructions
Filling of the water tank
Place the aroma diffuser on a flat, stable surface. Remove the outer cover and the water tank lid. Insert the ato-
mizer cover inside the hole found at the center of the tank, making sure it is firmly fixed. Using a cup or a little jug,
fill the tank with water, making sure that the level of liquid does not exceed the MAX line marked inside the tank.
Note: it is advisable to use pure water, mineral water or purified water, in order to avoid limestone and
residues that could obstruct the atomizer.
Add 2-3 drops of your favorite essential oil or fragrance.
Put the water tank lid and the top cover back into place, making sure that all components are well fixed.
Turning on the aroma diffuser
Insert the cable in the connector found on the motor base, and then connect it to a wall socket with a USB adap-
ter (not included), or to a device equipped with a USB port, making sure to avoid any water spilling.
Warning: do not move the diffuser when plugged to the wall socket or when operating, to avoid any
water leaking
To turn the light on, press the light button once: the light will automatically fade into the 7 different colors avai-
lable; to chose the color of the light, press the light button until the desired color appears. To turn the light off,
press the light button 9 times.
Press the timer and mist button to activate the mist function; by pressing the button once, mist function activates
in stay on mode, which means it will operate continuously until turning off or until water runs out. To activate
timer, press the timer and mist button again until the green light indicator lights up next to the desired available
option (30 / 60 / 90 min).
To turn the diffuser off, press the timer and mist button 4 times.
Note: The diffuser is integrated with a safety system that will automatically turn the appliance off when water level
is too low. If the diffuser turns off while operating (and the timer is not set), please check water level in the tank.
Note: room temperature, humidity, etc. could make mist coming out of the diffuser more/less visible
7
EN