HOMCOM 713-044 Mode D'emploi page 5

EN
Carefully regd the following instructions
for use
Only use this item in the manner described and
for the purpose for which it is intended. Store
these instructions for use carefully.
Maximum load: 150kg
Dimension: 22 x 18H cm
Adjusting the mounting width: 73.5-82.5cm (+/- 1-
2cm)
Seat length: 40.5 cm
Seat width: 22 cm
Purpose
The bathtub seat board is designed to provide a
stable seat when bathing in a standard bathtub. lt
is designed for people who have problems to sit
down and / or rise from the bottom of the bathtub.
WARNING
1.The seat board cannot be mounted on the
bathtub when the rubber pads, located on the
side of the brackets, do not have full contact with
the vertical(or almost vertical) wall of the bathtub,
as shown in Fig.2.
2.Always make sure that the seat board is
attached properly before using it.
3. Please check the condition of anti-slip tube cap
before each using.
4.This products is only for indoor use.
5.This product is not suitable for saunas or heat
cabins.
6.This product is not suitable for rehabilitation or
medical treatment of persons.
Safety advice
•"Smooth or damp surfaces may impair anti-slip
properties"
Do not step on seat.
•Do not lift together with person.
•Note: not for use in the rehabilitation or medical
treatment of persons.
•Service life for supporting components made of
plastic material is 2 years.
Assembly
1.Slide brackets and align the holes for bolt.
There are two holes on the rectangle fitting for
length adjust, please ensure the two hands can
be fixed well on the edge of tub. WARNING!
Please ensure the bolt is completely inserted and
lock the hands.
2.Place the rectangle fitting on the backside of seat
board, align the holes for screw.
3. Screw down the screws with gasket tightly and
ensure no sway between them. WARNING! lf, on
the one hand, the seat board protrudes significantly
beyond the edge of the bath tub, it can be
dangerous to the user and threaten to fall.
4.Check that the seat board is securely locked
before use. The seat board cannot be placed
asymmetrically relative to the bathtub edges, and
the protections must not adhere or only partially
adhere to the bathtub (Fig. 2).
Seal Boord
Bathtub
•Correct adhere on tub edge.
•Ensure each ends has enough
support from tub edge.
5.The above procedure should be used each
time when mounting the seat board on the
bathtub.
WARNING! Always before using the seat board
make sure that it is correctly and stably mounted
to the bathtub.
Cleaning and maintenance
1.It is recommended to regularly check the seat
board for any damage or visible signs of wear.
2.Regular cleaning is recommended. The seat
board should be cleaned with a soft cloth and
soapy water after each use it off. WARNING! Do
not use solvents, bleaches or abrasives to clean
the handle.
3
Wing nut
Fig.1
•partially adhered on tub edge cause
fall risk
DANGER！
Fig.2