Power Dynamics PDY215SA Manuel D'instructions page 3

UNPACKING INSTRUCTION
CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must be
returned, it is important that the product is returned in the original factory box and packaging.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
The label on the back/under side of the product indicates the mains voltage to which it must be connected. Check that the mains
voltage corresponds to this. Any other voltage than the one indicated may cause irreparable damage to the unit. The unit must
also be connected directly to the mains voltage and no dimmer or adjustable power supply may be used.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
CONTROLS AND CONNECTIONS
1. RCA LINE INPUT: RCA input for connecting audio units with line level
output (e.g. mixer, CD player).
2. COMBO JACKS LINE IN: Line signal entries, suitable for both XLR and
6.3mm jack.
3. XLR LINE OUTPUTS: XLR outputs for both line channels.
4. CROSSOVER LEVEL CONTROL: Knob to regulate the crossover
frequency between 80Hz and 150Hz.
5. HIGH PASS OUTPUT: This output is used to send the incoming signal to
a full range active speaker or power amplifier.
6. PHASE CONTROL: This switch reverses the polarity of the subwoofer.
Experiment (placement of the subwoofer relative to the speakers) with all
speakers to find the best sound.
7. MASTER OUTPUT LEVEL: Adjust the overall output level.
8. POWER CONNECTOR B: Socket for plugging in the supplied power
cord.
9. FUSE HOLDER: For instructions on how to replace the fuse, please see
chapter "REPLACING THE FUSE".
10. POWER SWITCH: Switch to turn the device ON or OFF.
REPLACING THE FUSE
If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
3