Sommaire des Matières pour Bull Dog Power Products WARNER 11067
Page 1
All manuals and user guides at all-guides.com #11067 TRIPOD WORKLIGHT STAND DANGER: THIS LIGHT IS NOT INTENDED FOR USE IN POTENTIALLY EXPLOSIVE ENVIRONMENTS. THIS IS NOT A VAPOR PROOF LIGHT. Warning: When using outdoor portable lights, basic safety precautions should be followed to reduce the risk of fire or electric shock. Failure to follow these instructions could result in personal injury, property damage, or death.
Page 3
All manuals and user guides at all-guides.com Operating Instructions 1. Plug the light into properly grounded circuit. 2. Turn the light on by pushing the rubber button switch located on top of the fixture. 3. Always make sure the light is placed on a firm level surface. Safety Instructions: 1.
Page 4
All manuals and user guides at all-guides.com Set Up the Tripod Stand: Loosen locking knob and pull legs away from center pole (out) until all three legs make contact with the floor. Retighten the locking knob when legs are firmly in place. Attach Portable Stand to Tripod Stand: Pinch the red locking buttons inward.
Page 5
All manuals and user guides at all-guides.com #11067 BASE TIPO TRÍPODE PARA LÁMPARA DE TRABAJO PELIGRO: ESTA LÁMPARA NO ESTÁ DISEÑADO PARA USO EN AMBIENTES POTENCIALMENTE EXPLOSIVOS. ESTA LÁMPARA NO ES A PRUEBA DE VAPOR. Advertencia: Cuando utilice lámparas portátiles en exteriores, se deben observar precauciones básicas de seguridad para disminuir el riesgo de incendio o descarga eléctrica.
Page 6
All manuals and user guides at all-guides.com Instrucciones de empleo 1. Enchufe la lámpara en un circuito adecuadamente conectado a tierra. 2. Encienda la lámpara presionando el interruptor con botón de goma ubicado en la parte superior de la unidad. 3.
Page 7
All manuals and user guides at all-guides.com Configure la base tipo trípode: Afloje la perilla de cierre y hale las patas lejos del poste central (afuera) hasta que las tres patas hagan contacto con el suelo. Vuelva a apretar las perillas de cierre cuando las patas estén firmes en su lugar.
Page 9
All manuals and user guides at all-guides.com 11067 SUPPORT DE LAMPE DE TRAVAIL TRÉPIED DANGER : CETTE LAMPE N’EST PAS CONÇUE POUR LES ENVIRONNEMENTS À POTENTIEL EXPLOSIF. CECI N’EST PAS UNE LAMPE ÉTANCHE À LA VAPEUR. Avertissement : Lors de l’utilisation de lampes portables, les consignes de sécurité...
Page 10
All manuals and user guides at all-guides.com Mode d’emploi 1. Brancher la lampe dans un circuit correctement mis à la terre. 2. Mettre la lampe en marche en appuyant sur l’interrupteur en caoutchouc situé sur le dessus de la lampe. 3.
Page 11
All manuals and user guides at all-guides.com Installer le support trépied : Dévisser le bouton de verrouillage et tirer les pattes vers l’extérieur jusqu’à ce que les trois pattes soient en contact avec le sol. Revisser le bouton de verrouillage lorsque les pattes son fermement en place.
Page 12
All manuals and user guides at all-guides.com BULLDOGPOWER.COM WARNERTOOL.COM 1-800-444-0606 Made in China Hecho en China 11067-0916 Fabriqué en Chine...