Intertek 990-3075 Mode D'emploi page 3

Installation (see Fig. 1 to Fig. 5)

Do not connect the appliance until it is properly fixed to the wall and that the
instructions are fully read.

The minimum distances must be observed in the diagrams.

When you are installing the appliance, care must be taken to not damage the concealed
cables.

Please be careful while drilling the holes.
Wall Mount Instructions

This appliance is designed to be fixed to a wall at a minimum height of 300mm. The
minimum distance from the top of the heater to the ceiling should be 1000mm. The
wall bracket must be fitted horizontally and the cables routed to the bottom right of the
heater.

A distance of 600mm from the bottom of the heater to the floor is recommended for
optimum viewing of the fuel chamber; see Fig. 1 below for recommended fixing
dimensions.

For optimum viewing, mark the top four screws. (Fixing positions on the wall in
accordance with the recommended fixing dimension); See Fig. 2
All manuals and user guides at all-guides.com
Fig.1
-3-
Note: Ensure the bracket is leveled by using a spirit level, whilst marking out the hole
positions.

Drill the holes with a No.6 drill bit (11/64 inches).

Fix the wall bracket using the plugs and the 6x25mm screws provided.

Carefully lift up the heater ensuring the top rear ledge of the heater engages with the
wall bracket (see Fig. 2) and is sitting centrally. This process should be carried out by
two people to avoid any injuries or damages to the property or the appliance.

Gently bring the heater down against the wall

Fix both side of the bracket with 2 pieces of the 4x8mm screws. (See Fig. 3A);
Fig.2
-4-