Publicité
Les langues disponibles
Les langues disponibles
7
7A
7D
7E
7C
7 TRIM FLANGE ATTACHMENT
Position Flange (7A) on Valve (7B) with Drain Hole (7C) at the bottom. Place
Protective Washer (7D) on the short end of the reversible Retainer Sleeve
(7E). Screw Retainer Sleeve (7E) onto threaded section of the Stem and
Bonnet (7G). Tighten Retainer Sleeve (7E) by hand until Flange (7A) is snug
to finished wall surface. If the short end of the Retainer Sleeve (7E) is too
short, reverse it to use the longer end.
8
8B
8A
8D
8C
8E
8 HANDLE ATTACHMENT
Screw Stem Extender (8A) onto the Valve Stem (8B). Thread the Set Screw
(8C) into the Handle (8D) and thread it in only three to four turns. With valve
in "CLOSED" position, place Handle (8D) onto the Stem Extender (8A) and
tighten the Set Screw (8C) by using the Hex Wrench (8E) that is provided.
Make sure Set Screw (8C) is securely tightened to handle (8D).
7G
7B
7C
ENGLISH
9
9A
9 SHOWER ARM INSTALLATION
Insert the longer end of Shower Arm (9A) through the Shower Flange (9B).
Apply PTFE plumber's tape to both ends of Shower Arm (9A) according to
manufacturer's instructions. Screw the end of Shower Arm (9A) into pipe elbow
inside the wall. Slide Shower Flange (9B) tight to the wall.
10
Option 1: Copper Pipe
10B
Option 2: Threaded Pipe
Remove
10 SPOUT INSTALLATION
COPPER PIPE: Screw Pipe Nipple (10A) into the elbow inside the wall and
tighten with pipe wrench. The Pipe Nipple (10A) is to project
the finished wall. Tighten Tub Spout (10B) into place with Screw (10D). Tighten
Spout until flush to the finished wall.
THREADED PIPE: Apply PTFE plumbers tape on both ends of Pipe Nipple
(10A) (not included). Screw Pipe Nipple (10A) into the elbow inside the wall and
tighten with pipe wrench. The Pipe Nipple (10A) is to project 3
the finished wall. Screw Tub Spout (10B) onto Pipe Nipple (10A) and tighten
until Spout is properly positioned and flush to the finished wall.
11 UNIT START UP
Turn on hot and cold water supplies, and check all connections for leaks.
3
9B
10A
1
⁄
" – 2
⁄
"
1
1
2
4
(38 mm – 57 mm)
10D
Chamfer and deburr
3/32 Hex Wrench
llave hexagonal de 3/32
clé hexagonale du 3/32
10A
10B
3
⁄
" – 4"
7
8
(98 mm – 101 mm)
" from
1
⁄
" – 2
⁄
1
1
2
4
⅞
" to 4" from
Publicité
