Recharge Mower G1-RM10 Manuel D'instructions page 11

ASSEMBLY
Before you open the carton of your New Recharge Mower, please review the following:
WE RECOMMEND YOU HAVE A SECOND PERSON ASSISTING-BEFORE YOU BEGIN
 The unit is virtually ready to go when received.
 Carefully CUT the straps that secure the over shipper carton to the base-remove
the straps and dispose.
 Remove the over shipper carton by lifting straight up and over the enclosed metal
frame that houses and protects the unit.
 You will find that there are a few items that need to be installed. DO NOT
assemble until you remove the metal frame portion-this is done using a Philips
(star) head screwdriver and pliers or adjustable wrench.
 Remove the nuts and bolts-they are NOT reused.
 Once the nuts and bolts are removed-lift off the metal frame. Again-this is NOT
reused. Finish un-assembling the frame.
 NOW-Lift the
with care. Remove any packaging and dispose.
 The steering wheel will then be inserted into the steering wheel sleeve
on the unit. It is designed to fit in 1 (one) direction-please take your time and
slide the steering wheel into the shaft (Step 2).
 Install the bolt to secure the steering wheel to the shaft (Step 3).
Step 1
ENSURE THAT THE WIRES HAVE BEEN SLIDE DOWN
ALONG THE SHAFT TO PREVENT DAMAGE!
-How To Set Up:
Steering wheel section
Step 2
-it is prewired-so handle
11
Step 3