Télécharger Imprimer la page

Hamilton Beach Commercial 19031 Mode D'emploi page 4

Publicité

Les langues disponibles

Les langues disponibles

840101400 ENv02.qxd
5/10/02
Features
(cont.)
Retractable Cord
1. Press and hold the Cord Release
Button while pulling cord to desired
length. Do not unwind cord beyond
the tape indicator on the cord.
2. To store cord, place the iron, soleplate
down, on ironing board. Unlatch
Retractable Cord Handle and wind
clockwise.
IMPORTANT! Do not press Cord
Release Button while winding cord.
Only wind clockwise or the cord may
jam. See illustration.
3. If cord jams while winding, push the
Cord Release Button to unwind slightly
until cord is free. Then slowly start to
wind clockwise again.
If Retractable Cord Handle
comes off, it is designed to snap
back in place.
1. Place pins of handle into slots in reel.
See illustration.
2. Lift handle up until it snaps in place.
1:28 PM
Page 6
Cord
Release
Button
Wind
clockwise
Retractable
Cord Handle
6
Caring for Your Iron
Iron
1. The water tank of your iron should be emptied after each
use. Turn Temperature Control Dial to Off. Unplug the iron
and hold over a sink. Slowly tilt pointed end of iron
down over sink. Water will run out of water tank opening.
2. After iron has completely cooled, store in an upright posi-
tion. Do not store iron laying flat on soleplate.
Soleplate
1. Never iron over zippers, pins, metal rivets, or snaps, as
these may scratch the soleplate.
2. To clean occasional build-up on the soleplate, wipe with a
sudsy cloth. Do not use abrasive cleansers or metal scour-
ing pads. Do not immerse in water.
3. Always store iron upright in the heel rest position.
Self-Clean
To keep the steam vents clear of any build-up, follow these
instructions each time you iron using steam.
1. Fill iron with water.
2. Plug in iron. Turn Temperature Control Dial to the highest
temperature.
3. Let iron heat for 3 minutes.
4. Turn Temperature Control Dial to OFF. Unplug iron and
hold over a sink with the soleplate facing down.
5. Turn Adjustable Steam Switch to Full Steam
and steam will flow out of the steam vents. Press the Blast
Button several times to increase cleaning.
6. Allow all water to drain from iron then let cool and store.
. Hot water
7

Publicité

loading